Gude GGH 10 INOX Originalbetriebsanleitung Seite 25

Failure removal
Error
Gas odour
The motor does not start
Piezo-ignition does not
ignite
No gas
Burner ignites, flame goes
off as soon as the gas valve
is turned on
Burner flame goes off
during operation
Causes
Gas hose or leaking connection.
No electricity
Electrode in incorrect position
Gas cylinder empty
Closed valve on the gas cylinder
Thermal element not yet hot properly
Safty thermostat turned off
Excessive gas output
Gas cylinder empty
Insufficient gas input
Wind or air draught extinguishes
flame
Remedy
Stop the gas supply to the device.
Move out of the danger zone immediately
and make sure that no other persons are in
the danger zone.
Call the fire brigade.
Check the cable, connect it to the power
supply and if necessary replace it or have it
repaired by an expert.
Call specialist
Replace gas cylinder
Open valve
Try again
Let the device cool down and then retry.
Have the reduction valve checked or replaced
Replace gas cylinder
Check and clean motor grid
Check fan
Place the device outside wind or air draught,
let it cool down for several minutes and then
retry.
ENGLISH
25