Emergency Procedure - Gude Ggh 10 Inox Originalbetriebsanleitung

The gas heater must not be used:
IT MUST NOT BE USED FOR HEATING HABITABLE
ROOMS IN RESIDENTIAL BUILDINGS; FOR USE
IN PUBLIC BUILDINGS, OBSERVE NATIONAL
REGULATIONS.
The device must not be operated in environments or
rooms below ground level.
Do not install the device in rooms at risk of explosions
and fire.
In the vicinity of combustible materials (e.g. paper, buil-
ding materials);
An explosive atmosphere may be created in places where
volatile materials (e.g. gasoline, solvents, chemicals) are
stored or present;
The apparatus is not intended for drying of clothing or
for installation under benches or in floor trenches.
Do not use the device in animal husbandry or animal
breeding.
After an arbitrary structural change in the gas heater; The
heater may not be operated without a fire protection
grille in its designated location. Only operate the device
when it is fully assembled!
In case of wrong, unauthorised connection to a gas
source;
In places that are not sufficiently ventilated;
As a source of heat for events and festivals.

Emergency procedure

Conduct a first-aid procedure adequate to the injury and
summon qualified medical attendance as quickly as pos-
sible. Protect the injured person from further harm and
calm them down. If you seek help, state the following If you seek help, state the following
pieces of information: pieces of information:
1. Accident site
2. Accident type
3. Number of injured persons
4. Injury type(s)
Safety instructions for Gas fan heater
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future refer-
ence.
Some regions have regulations that restrict
the use of the machine. Check with your local
authority for advice.
Warning - certain parts of the product may
get hot enough to cause burns.
Particular caution is called for if children and persons
requiring protection are present.
Only use the device in a well-ventilated environment
and away from combustible materials.
Do not use or store explosive or flammable materials
(e.g. fuel, paper, paints) in the vicinity of the product.
Keep the following safety distances:
Air intake side 2,5 m; Air outlet side 3,5 m;
side 2,0 m; top 2,0 m; back 2,5 m.
Do not put foreign objects in the device.
Make sure that the fan is operating properly before ignit-
ing the burner.
Never place the gas cylinder in front of the gas fan
heater when it is in use! This is a fire hazard!
It must always be ensured that air can be taken in and
vented freely.
The devices may not be used in atmospheres that con-
tain oil, sulphur or salt.
Do not set up in rooms at risk of fire (e.g. wood sheds).
Warning! - To prevent overheating, never
cover the heater with anything.
Do not use this heater with a program switch, a time
switch, a separate remote control system or any other
device that automatically switches the heater on, as there
is a risk of fire if the heater is covered or set up incorrectly.
Always switch off the device, as described in this manual,
if you cannot leave it in a safe state. Secure the device
against unauthorised use, e.g. by enclosing the gas
cylinders. Leave the premises, move to a clear place and
warn other people.
Warning! - Danger of short circuit!
Never operate/touch the device with wet hands.
Protect the electrical parts from moisture. To prevent
electrical shock, never submerse these parts in water or
other fluids during cleaning or when in operation. Never
hold the apparatus under flowing water.
Switch off the device and disconnect it from the power
supply before replacing accessory parts, cleaning work
and if it is not in use.
Operation is only allowed with a safety switch against
stray current (RCD max. stray current of 30mA).
Warning! - Damaged mains cords pose a
hazard of electrocution.
Handle the cord carefully. Hold the plug when unplug-
ging the tool. Never use the cord to carry the apparatus.
Keep cord away from heat, oil, sharp edges or moving
parts. Replace damaged cords immediately. Damaged
cords increase the risk of electric shock and may create
a fire.
If the replacement of the supply cord is necessary, this has
to be done by the manufacturer or his agent in order to
avoid a safety hazard.
Use extension cables with a maximum length of 5 meters
and with a cable cross-section of not less than 1.5 mm
ENGLISH
.
2
21