Gude GGH 10 INOX Originalbetriebsanleitung Seite 22

ENGLISH
Use of extension cables of different length and cross-
section and also of adapters and multiple sockets should
be avoided.
Warning! - Risk of asphyxiation and
explosion if leaks occur.
The device must be disconnected from the gas cylinder
after every use using the gas cylinder shut-off valve!
Prevent any torsion stresses on the connection hose.
Make sure that the gas hose is not twisted.
People are prohibited from being in the installation area
at any time.
Do not move the device when it is in use.
Always place the unit on a firm and flat surface!
Close the gas bottle valve after use.
Symbols
To reduce the risk of injury, user must read
instruction manual
Caution / Warning!
Before doing any work on the device pull the plug
out of the socket.
Do not tug at the cable to unplug the
apparatus.
European Conformity Mark
Warning against hot surfaces!
Danger of burns!
Covering the device poses a fire hazard!
Keep distance of persons
Observe to keep out of dangerous zone
Warning! Danger: high voltage
Warning about inflammable substances
Keep dry at all times. Never expose tool to
rain.
Do not use the device indoors
22
Open flames are prohibited
Keep the machine out of reach of children.
Protect against frost.
Güde GGH 17 INOX
A +++
A
A ++ + A ++
A A + A
+
A
B
C
D
Energy Efficiency Class A
E
F
G
17,0
kW
ENERGIA · · ΕΝΕΡΓΕΙΑ · ENERGIJA · ENERGY · ENERGIE
2015/1186
300 mbar
Operating pressure P
500 mbar
Gas valve
GAS
Fan
PIEZO
Piezo ignition
Connect the pressure regulator to the gas
cylinder valve and attach the gas hose to the
GAS
pressure regulator.
Put the mains cable into a suitable socket.
Open the gas cylinder valve.
GAS
Switch on the device with the toggle switch
and check from the intake side whether the
fan is rotating.
Keep the gas valve knob pressed for approx.
10 seconds until the thermal fuse has
warmed up and keeps the gas supply open.
GAS PIEZO
Then ignite using the piezo button.
Close the gas cylinder valve to switch off.
Then let the fan run for 1-2 minutes to blow
out any non-combusted gas and cool down
GAS
the device.
Switch off the device at the toggle switch
and disconnect it from the gas cylinder by
unscrewing the pressure regulator from the
GAS
gas cylinder valve.
Any damaged or disposed electric or electro-
nic devices must be delivered to appropriate
collection centres.