Important Notes, Recommendations And Faqs - ARMODD Roundz 4 Bedienungsanleitung

EN

Important notes, recommendations and FAQs

1. To save the values measured and the current date and time, make
sure you synchronise the smartwatch with the app on a daily
basis. During the night, the values measured by the smartwatch
may reset.
2. This product is not a medical device. Neither the smartwatch nor
the app are intended for the diagnosis, treatment or prevention
of illnesses and symptoms thereof. The values measured are
illustrative and may differ from values measured by certified
medical devices as well as because of the method of measurement
and tightness of the strap. The sensor on the reverse side of the
smartwatch must be in contact with the wrist, and the strap must
be tight. If the strap is loose and the sensors dirty, the precision of
the measurements will be compromised.
3. In order to ensure correct date and time settings, the smartwatch
must be paired with a phone. Then the date and time will be set
automatically.
4. The smartwatch has the IP67 degree of protection. We re-
commend avoiding contact of the smartwatch with water under
pressure, fast and rapidly flowing water, spraying and hot water
and steam, because when using the smart watch, due to wear
and tear of the case or its mechanical damage and microscopic
cracks in the seal, water can penetrate into the smartwatch and
68
cause damage.
5. You have stopped receiving incoming calls or SMS notifications
– check that the smartwatch is paired with your phone and the no-
tifications are allowed in the app (Fig. 3) and in the settings of your
phone, and that the do-not-disturb mode has not been activated in
the app. Make sure Bluetooth is on in your phone. Do not pair the
smartwatch via the phone's Bluetooth menu.
6. The smartwatch cannot be paired with a phone – possible
solutions:
- make sure the smartwatch and phone are charged sufficiently
- make sure your phone's Bluetooth and GPS are switched on and
you have allowed your location/position to be tracked
in your phone's settings
- place the smartwatch and the phone next to each other
- check the system updates in your phone
- uninstall and re-install the app
- restart your phone and switch the smartwatch off then back on
again
- make sure your phone meets the technical requirements
(Android 5.1+, iOS 9.0+, Bluetooth 5.0+)
7. The green sensor light is blinking – data measurement or transfer
is underway.
8. The green sensor light blinks even when the smartwatch is not
being worn – it is not a flaw.