Important Notifications, Recommendations And Faqs - ARMODD Squarz 9 Pro Bedienungsanleitung

EN CZ
Other functions must be set and allowed in the WearPro
app (Fig. 3), and their operation depends on both the
specific phone model and settings as well as the current
version of the watch. These include various notifications
(calls, SMS, social media), alarm, remote shutter, do
not disturb mode, prolonged sitting reminder, display
activation by wrist movement, etc.
Important notifications, recommendations
and FAQs
1. To save the values measured and the current date
and time, make sure you synchronise the watch with
the app on a daily basis. During the night, the values
measured by the watch may reset.
2. This product is not a medical device. Neither the
watch nor the app are intended for the diagnosis,
treatment or prevention of illnesses and symptoms
thereof. The values measured are illustrative and may
differ from values measured by certified medical devi-
ces as well as because of the method of measurement
and tightness of the strap. The sensor on the reverse
side of the watch must be in contact with the wrist,
and the strap must be tight. If the strap is loose and
the sensors dirty, the precision of the measurements
will be compromised.
3. In order to ensure correct date and time settings, the
watch must be paired with a phone. Then the date
and time will be set automatically.
4. We strongly recommend preventing the watch
coming into contact with water. The watch is not to
be used in wet environments, e.g. when bathing,
swimming, showering, diving, etc. The watch is not
water resistant and water may damage the interior.
Attention must also be paid to hot (warm) water,
88
steam, etc., as it may (due to wear and tear of the
casing, mechanical damage or microscopic cracks
in the seal) seep into the watch and cause damage.
Upon coming into contact with water, immediately dry
the watch thoroughly. Damage by water or steam is
not covered by warranty.
5. You have stopped receiving incoming calls or SMS
notifications – check that the watch is paired with
your phone and the notifications are allowed in the
app [Notifications (Fig. 3)] and in the settings of your
phone, and that the do-not-disturb mode has not
been activated in the app. Make sure Bluetooth is on
in your phone. Do not pair the watch via the phone's
Bluetooth menu.
6. The watch cannot be paired with a phone – possible
solutions:
- make sure the watch and phone are charged
sufficiently
- make sure your phone's Bluetooth and GPS are
switched on and you have allowed your location/
position to be determined in your phone's settings
- place the watch and the phone next to each other
- check the system updates in your phone
- uninstall and re-install the app
- restart your phone and switch it off then back on again
- make sure your phone meets the technical require-
ments (Android 5.1+, iOS 9.0+, Bluetooth 5.0+)
7. Sensor light is blinking – data measurement or
transfer is underway.
8. The green sensor light blinks even when the watch is
not being worn – it is not a flaw.
9. To ensure the correct function of the watch, it is re-
commended that it be restarted or reset occasionally
and, where available, that firmware be updated in
the app. Make sure you always have the most recent
version of the app.
10. Always charge the watch for no more than 2 hours
EN CZ
89