Disassembly And Storage - Bestway 56432 Bedienungsanleitung

Parameters
Water clarity
Colour of the water
Turbidity in FNU/NTU
Nitrate concentration above that of fill water in mg/l
Total organic carbon (TOC) in mg/l
Redox potential against Ag/AgCI 3,5 m KCl in mV
pH value
Free active chlorine (without cyanuric acid) in mg/l
Free chlorine used in combination with cyanuric acid in mg/l
Cyanuric acid in mg/l
Combined chlorine in mg/l
• Over usage of chemicals will discolor the printing and all points of the pool material; in worst cases, it will damage the structure of the pool liner.
• Pool chemicals are potentially toxic and should be handled with care. There are serious health risks from chemical vapors and the incorrect
labeling and storage of chemical containers.
• Please consult your local pool or chemical supply retailer for more information about chemical maintenance. Pay close attention to the chemical
manufacturer's instructions.
• The pump is used to circulate the water and to filter small particles. In order to keep your pool water clean and hygienic, you must also add
chemicals.

DISASSEMBLY AND STORAGE

DRAINING
• For draining, follow the drawings inside the manual. Drawings are for illustration purposes only. May not reflect actual product. Not to scale.
• To drain your pool water, check local regulations for drainage by-laws.
CLEANING
• Rinse the pool liner with tap water, to remove any residual of chemicals or dirt completely.
• Leave the pool under the sunlight until it's completely dried.
• To remove the remaining water completely, wipe the pool liner with a dry cloth.
STORAGE
• Remove all accessories; be sure that pool liner and accessories are completely clean and dry before the storage. If the pool is not completely dry,
mold may result and will damage the pool liner during the storage period.
• Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together.
• We strongly recommend disassembling the pool when the environment temperature is below 10ºC / 50ºF.
• Fold the pool liner only if the environment temperature is above 10ºC / 50ºF. Store the pool in a dry place with a moderate temperature between
10ºC / 50ºF and 38ºC / 100ºF and position the pool liner and all accessories inside a carton box, to better protect the PVC material during the
winter period.
REPAIR
In the event of a leak, patch your pool using the underwater adhesive repair patch provided. You can find the instructions in FAQs on the support
section of our website, www.bestwaycorp.com/support.
Values
clear view of the pool bottom
no colour should be observed
max. 1,5 (preferably less than 0,5)
max. 20
max. 4,0
min. 650
6,8 to 7,6
0,3 to 1,5
1,0 to 3,0
max. 100
max. 0,5 (preferably close to 0,0 mg/l)
7