Safety Notices And Directions Relating To The Technical Condition; Safety Notices And Directions Relating To Transport, Assembly, Installation - elero Junior 1 Montageanleitung

Safety
2.5 Safety notices and directions relating to the technical condi-
tion
The device must be checked before installation for damage and proper
❏
condition.
The plant operator is obligated to operate the device only in perfect and
❏
operationally safe condition. The technical condition must comply with the
legal requirements at all times.
If dangers to personnel or changes in operating behaviour are recognized,
❏
the device must be shut down immediately and the incident reported to your
superiors or to the plant operator.
The device may only be connected to the energy supply intended and de-
❏
signed for this purpose. Please refer to the type plate for the permissible
type of voltage and operating voltage.
No changes, attachments or conversions may be performed on the device
❏
without the authorization of the manufacturer.
If wear is detected on the trapezoidal or ball screw spindle or on the spindle
❏
nut, the device must be brought to the manufacturer for maintenance.
2.6 Safety notices and directions relating to transport, assembly,
installation
The relevant transport company is fundamentally responsible for the transport
of the device. The following safety requirements must be complied with during
transport, erection and installation of the device.
During transport the device has to be secured in accordance with the regu-
❏
lations of the auxiliary transport means being used.
For transport only hoist and slings may be used that are dimensioned so
❏
that they can safely bear the forces that occur during loading, unloading and
installation of the device.
Only the points defined on the pallet and device are allowed to be used as
❏
lifting and hoisting points:
If work is required on lifted parts or work devices, these must be secured
❏
against falling by means of suitable devices. Work equipment for the lifting
of loads must prevent loads from shifting unintentionally, falling unhindered
and unhooking unintentionally.
Standing under suspended loads is prohibited.
❏
A hard hat must be worn during loading work with hoists.
❏
The erection and installation work may be performed fundamentally only by
❏
trained and instructed skilled personnel.
10