Foreseeable Misuse; Warranty And Liability - elero Junior 1 Montageanleitung

General
If a direct or indirect hazard to personnel cannot be ruled out, additional meas-
ures (e.g. covers, barriers, etc.) must be taken in order to minimise the potential
risk accordingly.
The operator alone is liable for any damage arising from the non-intended use
of the device. The manufacturer assumes no liability for personal injury or dam-
age to property caused through misuse or procedural errors, improper operator
control or improper start of operation.
The device must be operated only by trained and authorized skilled personnel
subject to compliance with all safety notices and directions.
Safe and error-free use and operating safety of the device can only be guar-
anteed subject to use in compliance the intended use in accordance with the
specifications set out in these installation instructions.
Intended use includes observation of and adherence to all the safety notices
and directions instructions specified in these installation instructions, as well as
all applicable regulations of trade associations and the valid laws in relation to
environmental protection. Use in compliance with the intended use also includes
adherence to the operating regulations prescribed in these installation instruc-
tions.
1.4

Foreseeable misuse

Any installation into other equipment that deviates from the purpose cleared by
the manufacture applies as being a foreseeable misuse.
1.5

Warranty and liability

In principle, the General Terms & Conditions of Sale and Delivery of the manu-
facturer apply. The Terms & Conditions of Sale and Delivery are a component
part of the sales documentation and are handed over to the plant operator at the
time of delivery. Liability claims for personal injury and damage to property are
excluded, if they are attributable to one or several of the following causes:
• Opening of the device by the customer (breaking the seal)
• Use not in compliance with the intended use of the device
• Improper installation, start of operation or operator control of the device
• Changes to the design and construction of the device without the written
approval of manufacturer
• Operation of the device with improperly installed connections and defective
or improperly attached safety and protection devices
4