Battery Care - Tesla RoboStar iQ300 Bedienungsanleitung

The vacuum
cleaner stops
cleaning and
returns to the
3
charging base
prematurely.
The vacuum
cleaner will not
start cleaning as
scheduled.
4
Remote control
5 does not work (RC
range is 5 meters)
If this does not solve the problem, check that the battery is fully charged and then turn the vacuum
cleaner off and on using the „Main power switch".

BATTERY CARE


In case of low battery detection during cleaning, the vacuum cleaner automatically searches the
charging station and starts charging

Keep the charging station switched on continuously, if it is not turned on, the vacuum cleaner can
not find it.

If you are carrying a robotic vacuum cleaner or you will not be using it for a long time, turn it off
with the main switch.

If you do not use the device for a long time, remove the batteries from the remote control.

The robotic vacuum cleaner is equipped with a high-capacity, modern Li-Ion battery, without
memory effect, so don't worry about multiple battery charging and discharging.

The vacuum cleaner is equipped with a special protection that stops supplying power after
If the battery level decreases, the
vacuum cleaner will automatically
switch to charging dock and return
to the charging base.
The operating time varies
depending on the floor surface, the
complexity of the room and the
cleaning mode selected.
The vacuum cleaner is switched
off or the battery is low.
You have not saved the scheduled
cleaning in the vacuum cleaner
memory.
The vacuum cleaner is blocked.
Weak batteries in remote control.
The vacuum cleaner is not
switched on or the battery is not
sufficiently charged to start
cleaning.
The infrared sensor on the remote
control is dirty or the infrared
sensor on the vacuum cleaner is
dirty.
There is interference between the
remote control and the vacuum
cleaner.
Normal condition, charge the
vacuum cleaner to its full
capacity and start cleaning
again.
Normal state, there is no need to
solve.
Turn on the vacuum cleaner and
charge the battery.
Re-enter the time and day in the
vacuum cleaner memory and
make sure that the vacuum
cleaner is fully charged.
Switch off and clean the vacuum
cleaner.
Replace the batteries, observing
the correct polarity when
inserting them.
Make sure the vacuum cleaner is
turned on and recharge the
vacuum cleaner battery.
Clean the remote control and
vacuum cleaner.
Avoid using near other infrared
devices.