Technical Data - Meec tools 018936 Bedienungsanleitung

• The tool must not be used by persons
under 18.
• Do not touch the bit during or
immediately after use – risk of burn injury.
• Do not put your hands under the workpiece.
• Never use your hands to remove sawdust,
chips or debris near the bit.
• Keep the work area free from rags, loose
clothing, and string, etc.
• If you are disturbed, complete the job and
switch off the tool before taking your
attention away from the tool.
• Wear suitable safety equipment such as
safety glasses, ear protection and safety
gloves. Wear a dust filter mask if the work
produces a lot of dust.
• Only use the tool for its intended purpose.
The tool must only be used for its intended
purpose and in accordance with these
instructions. All other use is considered to
be unsuitable. The manufacturer cannot
accept liability for any damages resulting
from improper usage.
SYMBOLS
Read the instructions.
Safety class II.
Wear ear protection.
Wear safety glasses.
Wear a dust filter mask.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Rated voltage
Output
Chuck size
Capacity in concrete
Capacity in steel
Capacity in wood
Speed
Stroke rate
Cord length
Weight
Sound pressure level, LpA 96.4 dB(A), K=3 dB(A)
Sound power level, LwA 107.4 dB(A), K=3 dB(A)
Vibration drilling in metal ah, D
Vibration percussion drilling in concrete ah, ID
Always wear ear protection!
The declared values for vibration and noise,
which have been measured by a standardised
test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 62841-2-1:2018.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
230 V ~ 50 Hz
1050 W
13 mm
13 mm
8 mm
25 mm
900 rpm
0-19200 / 0-51200/min
3 m
2.8 kg
2.565 m/s², K=1.5 m/s
9.891 m/s², K=1.5 m/s
EN
31