Power Switch; Power Supply - Meec tools 018936 Bedienungsanleitung

EN
DESCRIPTION
PARTS
1. Chuck
2. Speed control
3.

Power switch

4. Lock button for power switch
5. Switch for percussion function
6. Support handle
7. Gear selector
FIG. 1
USE
The product is an impact drill intended for
drilling in wood and metal, and in concrete
with the percussion function.

POWER SUPPLY

The plug on the power tool must match the
power point. Never use an adapter with
earthed power tools. Check that the mains
voltage corresponds to the rated voltage on
the type plate.
SUPPORT HANDLE AND DEPTH
STOP
IMPORTANT:
Switch off the tool and pull out the plug
before adjusting, replacing parts, lubricating,
cleaning or maintenance.
1. Open the handle holder by turning the
support handle anticlockwise and moving
the handle holder over the chuck.
FIG. 2
2. Adjust the position of the support handle
to personal preference. The support
handle can be rotated 360°.
32
3. The depth stop is used to drill holes with
a precise depth, or several holes with the
same depth. Release the support handle,
set the depth stop to the required position
and tighten the support handle.
FIG. 3
POWER SWITCH
WARNING!
Check that the power switch is in the OFF
position before plugging in the power cord.
Discontinuous operation (without power
switch lock)
Press the power switch to start the product and
then release it to switch off the product.
Continuous operation (with power switch
lock)
Press the power switch and lock button to start
the product and lock the power switch in the
ON position. Release the power switch lock to
switch off the product.
Adjusting the speed
The speed and torque increase the further in
the switch is pressed.
There is a knob on the power switch to adjust
the maximum speed reached when fully
pressing in the power switch. Turn towards "+"
to increase the maximum speed and towards
"–" to reduce.
FIG. 4
NOTE:
The maximum speed can also be set when
the product is switched off.