Ryobi RLC18 Bedienungsanleitung Seite 4

IMPORTANT!
It is essential that you read the
instructions in this manual before
assembling, operating,
maintaining the product.
Subject to technical modifications.
Safety, performance, and dependability
have been given top priority in the
design of your area light.
INTENDED USE
The area light is intended for general
illumination. Do not use the product in
wet conditions.
Do not use the product for any other
purpose. Use of the product for
operations different from intended could
result in a hazardous situation.
AREA LIGHT SAFETY WARNINGS
The light source of this luminaire
is not replaceable. When the light
source reaches its end of life the
whole luminaire shall be replaced.
Use only with recommended battery
pack and charger. Any attempt to
use another battery pack will cause
damage to the product and could
possibly explode, cause a fire, or
personal injury.
Do not disassemble the product.
If wrapped or in contact with fabrics,
the lens can produce sufficient
heat to melt some fabrics. To avoid
serious personal injury, never allow
the lens to come in contact with
anything.
Do not place the product or battery
pack near fire or heat. This will
reduce the risk of explosion and
possible injury.
Remove the battery pack before
starting any work on the product.
Do not store the product in a damp
or wet location, or in a location
where the temperature may reach
or exceed 40°C. For example, inside
sheds, vehicles, or metal buildings in
the summer.
2
Original Instructions
BATTERY SAFETY WARNINGS
To reduce the risk of fire, personal
injury, and product damage due to
and
a short circuit, never immerse your
tool, battery pack or charger in fluid
or allow a fluid to flow inside them.
Corrosive
such as seawater, certain industrial
chemicals, and bleach or bleach-
containing products, etc., can cause
a short circuit.
TRANSPORTING
TERIES
Transport the battery in accordance
with local and national provisions and
regulations.
Follow all
on packaging and labelling when
transporting batteries by a third party.
Ensure that no batteries can come
in contact with other batteries or
conductive materials while in transport
by protecting exposed connectors with
insulating, non-conductive caps or
tape. Do not transport batteries that
are cracked or leaking. Check with the
forwarding company for further advice.
KNOW YOUR PRODUCT
See page 55.
1. LED lens
2. Power button
3. Hanging bracket
4. Battery port
5. Operator's manual
6. Battery pack
7. Charger
MAINTENANCE
Use only original accessories and
spare parts. Should components
need to be replaced which have
not been described, please contact
an authorised service centre. All
repairs should be performed by an
authorised service centre.
Avoid using solvents when cleaning
plastic parts. Most plastics are
susceptible to various types of
or conductive fluids,
LITHIUM BAT-
special requirements