Werbung
GB
1. Mounting the front wheels
Slide a washer (13) onto the front axle. Now push the front wheel (10) onto the front axle. Press
the button in the middle of the wheel until it audibly engages. Repeat this on the other side.
Mounting the rear wheels
To mount the rear wheels, push a rear wheel (8) onto the rear axle. You can recognize the rear
wheels by the elevation that fits into the rear drive unit. Now push the rear wheel (8) onto the
rear axle. Press the button in the middle of the wheel until you hear it click into place. Repeat
this on the other side. Check the tight fit of all wheels by pulling the wheel. If the button on
the wheel protrudes a little from the rim, the wheel has engaged correctly.
Mounting the chassis reinforcements
Screw the chassis reinforcements (9) to the bottom right and left of the body.
2. Mounting the dashboard and steering wheel
First connect the plug on the dashboard cable (11) to the black plug protruding from the front of
the chassis interior (1). Connect the cable in the steering wheel to the cable in the steering
column. Then slide the steering wheel (4) onto the handlebar and tighten it. The hole position is
fixed by a nut.
3. Mounting the windscreen
The windscreen (3) is latched into the holes in the chassis at the dashboard level. Ensure that
the windscreen is firmly seated.
4. Battery connection
Connect all connectors as shown. Only connect plug connections that fit into each other and
take care not to reverse polarity. Make sure that the red cable (plus) and the black cable
(minus) are connected to the respective connectors of the same colour. Switch on the vehicle
by pressing the red button on the right side of the dashboard.
5. Mounting the brackets and the rear wing
First press the two brackets (6) into the oval holes provided for this purpose. Click the rear
spoiler (7) into the oblong holes on the boot lid of the vehicle.
6. Mounting the seat
Insert the two pins at the rear end of the seat (5) into the holes provided for this purpose. Take
two of the enclosed screws (14) and fix the seat (5) with them.
7. Mounting the rear-view mirrors
Insert the two mirrors (2) into the holders provided and screw them tight. Please take care not
to swap the sides.
A
Funktionen
A
Soundboard
B
Speed
High speed - Change the speed of the car more quickly.
Low speed - Change the speed of the car more slowly.
Important operating information:
In 1st gear the engine power is reduced and the rear wheels can turn at different speeds
depending on the load. This allows slower driving and, above all, a small turning circle. This also
means that in first gear, when starting off, or when driving over a small obstacle on one side, the
loaded wheel can stop and the driving force is transferred to the unloaded wheel. In order to
achieve full engine power and to distribute the driving force evenly over both wheels, it is
necessary to shift into 2nd gear. Attention! In 2nd gear not only the speed increases but also a
larger turning circle is achieved.
C
Shift Lever
Forward:
Press the "Forward-backward switch" on the "Forward" position. Press the Foot
pedal", the model drives forward.
Reverse:
Press the "Forward-backward switch" on the "Backward" position. Press the Foot
pedal, the model drives backward.
Important!
The vehicle must be stationary before changing direction or speed. Otherwise the gear
unit and/or the motor could be damaged.
D
Light button
E
ON/OFF Switch
With the ON/OFF switch you start the vehicle.
Caution
Always switch off the model immediately after each use. Immediately after each use the battery should be disconnected from the model. The battery can be deeply
discharged by leaving it switched on accidentally or leaving it plugged in. Deep discharge causes the battery to lose power or can be damaged to such an extent that
charging or discharging is no longer possible or the battery can self-ignite during charging or discharging (fire hazard). Never attempt to charge or discharge deeply
discharged batteries. The battery voltage should never fall below 11,9 volts to avoid deep discharge. The fully charged battery has a voltage of approx. 13 Volt. After use,
the intact battery should be fully charged immediately after a cooling phase of at least 10 minutes but at the latest after 12 hours to avoid subsequent deep discharge by
self-discharge. If the battery is not used or stored for a longer period of time, the battery should be checked for voltage (min. 12,3 volts) or damage at least every 3 months
and charged or disposed of if necessary.
8
8. Charging Your Vehicle
Warning!
•
•
•
•
• Let the model cool off sufficiently after each use before putting it back into operation.
• Always disconnect the model from the charger immediately after charging. Always
•
B
D
E
C
Soundboard
a
b
c
d
e
f
g
h
• The power swich must be turned in OFF position when charging.
• Insert the charger (12) into the socket - the LED lights up green. Connect the charger to
the charging socket.
• The LED on your charger lights up red as long as the battery is being charged. If the LED
lights green again, the battery is fully charged.
• The charge time is 6 hours.
• Do not charge the battery more than once within 24 hours.
• Charger and battery heat up during the charging process.
The charger is not a toy. Only use the charger supplied.
The battery may only be charged by or under the supervision of an adult.
The terminals must not be short-circuited.
The charger must be checked regularly for damage to the cable, plug, housing and other
parts. If any damage is found, the charger must not be used until the damage has been
repaired.
When using an additional batteries let it cool off for minimum 15 minutes until the
model is operated again. Overheating can damage the electronics or may result in fire.
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
to the model, charger or the power supply (fire hazard).
Use the charger only in dry rooms.
A
a
h
b
c
USB
Micro SD
After inserting a Micro SD card or USB stick, the soundboard starts playing the tracks one after
the other. Only files with the extension .mp3 can be played back.
Aux
Connect MP3 device / mobile.
Music/-V
Press = previous, long press = Volume down
Pause & play
Music/V+
Press = Next, long press = Volume up
Mode-button
Voltage disply
Attention!
Your vehicle displays the total voltage of the two batteries in volts immediately after switching
on. The fully charged batteries will usually display a total voltage of approx. 12.6-13 volts
unloaded. The display is load dependent. This means that the displayed voltage will drop under
load. If a voltage of less than approx. 11.8V is displayed in the unloaded state, you should switch
off the Ride-on and charge the battery (see charging procedure). Otherwise the battery may be
deeply discharged and irretrievably damaged. Otherwise, the battery may become deeply
discharged and be irretrievably destroyed. A deeply discharged battery is not covered by
the warranty and must be replaced at a charge.
d
e
f
g
Werbung
