Optional Accessories; Hard Water Kit (Apwm062); Apwm 019/020 Connector Box - Miele PWM 520 EL/RH Installationsplan

en - Installation notes
Hard water kit
(APWM062)
APWM 019/020
Connector Box
Peak load / energy
management
Liquid dispensing
connection
Payment device
32

Optional accessories

Only use genuine Miele spare parts and accessories with this ma-
chine.
Using spare parts or accessories from other manufacturers will in-
validate the guarantee, and Miele cannot accept liability.
The hard water connection on the washing machine can be retrofitted
with the optional hard water kit (APWM062).
The additional water connection allows hard water to be used and
the programme running time will therefore be reduced. In addition,
hard water is particularly suitable for the final rinse cycles.
The Connector Box allows external hardware from Miele and other
suppliers to be connected to the Miele Professional washing ma-
chine.
Flowmeters for the water inlet can also be connected to the Con-
nector Box (APWM 065).
A peak-load or energy management system can be connected via the
Connector Box.
The peak-load negotiation monitors the energy consumption of a
system and deactivates individual pieces of equipment temporarily
in order to ensure that certain total load limits are not exceeded.
Monitoring is externally controlled.
When the peak-load function is activated, the heating is deactivated
and the programme stopped. A message appears in the display to in-
form you of this.
The programme is resumed automatically when the peak-load func-
tion finishes.
External liquid dispensing pumps with a "container empty" indicator
or flowmeter can be used to dispense liquid detergents.
The dispensing pumps can only be programmed by the Miele Cus-
tomer Service Department using the Miele Diagnostic Support sys-
tem (MDU).
It is particularly important to observe manufacturer's instructions
when using a combination of cleaning agents and special application
products.
The washing machine can be fitted with a single-machine payment
system as an optional accessory via the Connector Box.
The programming required for connecting a payment system can be
carried out during the initial commissioning process. After initial com-
missioning, changes may only be carried out by your Miele dealer or
the Miele Customer Service Department.