Maintenance - Flex SKD 2902 VV Bedienungsanleitung

PLUNGE CUTS
The SKD 2902 VV can be used for plunge cutting wood, plywood, wallboard, and plastic
materials. DO NOT attempt to plunge cut metal.
Clearly mark line of cut on the work. Set saw for orbital motion to get the best plunge cut per-
formance. Grasp front housing with one hand and rear handle with the other hand. To start
cut, rest saw on shoe bracket, align blade with the marked line of cut, (blade NOT touching
work), as shown in Fig. 13. Start saw. Using bracket as a pivot point, roll saw forward by
raising rear handle, as shown in Fig. 14. When blade has cut through the work, continue
raising the rear handle until saw is perpendicular to the work surface. Keep saw in this position
and move blade along line of cut.
SAWING METAL
When cutting angle, H-beam, I-beam, channel, etc., start the cut on the surface where the
greatest number of teeth will contact the work. To make a pocket cut, drill a starting hole first.
To extend blade life, cutting oil can be applied to the work surface along the line of the cut.

MAINTENANCE

KEEP TOOL CLEAN
Periodically blow out all air passages with dry, compressed air. All plastic parts should be
cleaned with soft damp cloth. NEVER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
WARNING: Wear ANSI Z87.1 safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are making
good contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.
BRUSH INSPECTION AND LUBRICATION
For your continued safety and electrical protection, brush inspection and replacement on
this tool should ONLY be performed by an Authorized Service Agent for FLEX Power Tools.
At approximately 100 hours of use, take or send your tool to your nearest Authorized
Service Agent for FLEX Power Tools to be thoroughly cleaned and inspected; worn parts
replaced, and when necessary; relubricated with fresh lubricant, if required; reassembled
with new brushes; and performance tested.
Any loss of power before the above maintenance check may indicate the need for
immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL UNDER THIS
CONDITION. If proper operating voltage is present, return your tool to the Service Agent for
immediate service.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due to wear from
normal use. These operations, including brush inspection and replacement, should ONLY be
performed by an AUTHORIZED Service Agent for FLEX Power Tools. All repairs made by these
agencies are fully guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at any time. In any
communications, please give all information shown on the nameplate of your tool (model
number, type, serial number, etc.).
4