NORAUTO NS-228 BT Hinweise Zur Bedienung Seite 89

Installation/Connection
Basic Procedure
1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Make proper input and output wire connections.
3 Install the unit to your car.
4 Reconnect the
5 Reset the unit.
Warning
Ì The unit can only be installed in a car with a 12 V DC power
supply, negative ground.
Ì If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those wires
to the power source running through the fuse box.
Ì Disconnect the battery's negative terminal and make all
electrical connections before installing the unit.
Ì Insulate unconnected wires with vinyl tape or other similar
material. To prevent a short circuit, do not remove the caps on
the ends of the unconnected wires or the terminals.
Ì Be sure to ground this unit to the car's chassis again after
installation.
Disassembly
Trim plate
1
2
Disassembly
Control panel
terminal of the car battery.
Sleeve
3
EN
89