Troubleshooting Table - hanseatic HAP40065SWKC Gebrauchsanleitung

Page EN-16

Troubleshooting table

Troubleshooting table
Malfunctions can occur in all electrical appliances. This does not necessarily mean there is a
defect in the appliance. For this reason, check the tables to see if you can correct the malfunction.
WARNING
Risk of electric shock in case of improper repair!
■ Never try to repair the appliance yourself. You can put your own and future users'
lives in danger. Only authorised specialists are allowed to carry out this repair work.
Problem Possible cause
The power button (7) has not
been pressed.
Mains plug is loose.
Appliance is not
working.
The socket is defective.
The motor is defective.
Appliance is poorly positioned
or air exchange is obstructed.
The filters haven't been
No purification
cleaned/changed for a long
effect, odours are
time.
not adequately
The (new) filter is still in the
removed.
packaging film.
The appliance is placed in
a position where the sensor
cannot adequately measure
The PM2.5
the air quality.
pollution display
The PM2.5 sensor filter (14) is
does not change.
dirty.
The Filter Change No reset has been carried out. Carry out a reset after the filter change
Reminder
LED (12) does
not go out after
changing the filter.
Solutions, tips
Switch the appliance on.
Check that the mains plug is firmly
inserted into the socket.
Try the appliance with a different socket.
Check fuses and/or circuit breakers.
Contact our service department, (see
„Service" on page EN-17).
Find another location or remove
obstacles.
Clean or replace filter (see "Cleaning the
filters" on page EN-13).
Remove the filter and remove the
packaging film. Then insert the filter
again (see "Remove filter packing" on
page EN-10).
Select another location.
Clean the PM2.5 sensor filter (see
page EN-14).
(see page EN-11).