Cleaning The Pm2.5 Sensor Filter; Changing The Filters; Changing The Activated Carbon Filter - hanseatic HAP40065SWKC Gebrauchsanleitung

Page EN-14 Care and maintenance
apply high pressure as this may damage
the filter.
5. Then replace both filters.
6. Insert the filter cover (4) at the bottom and
fold it closed.
Cleaning the PM2.5 sensor
filter
The PM2.5 sensor is located on the left-hand
side of the appliance, below the carrying re-
cess. Also clean the PM2.5 sensor filter (14)
from time to time, to guarantee precise H13
measurement.
1. Loosen the screw with the help of a
cross-headed screwdriver and remove
the cover (13).
The PM2.5 sensor filter (14) is now acces-
sible.
(13)
(14)
2. Take the PM2.5 sensor filter (14) out of
the holder.
3. Clean the sensor filter first with a brush
and then under running water.
4. Then allow it to dry completely. Only rein-
sert it when it is completely dry.
5. Reattach the cover (13).

Changing the filters

When one of the Filter Change Reminder
LEDs (12) lights up, the corresponding fil-
ter (5) or (6) must be replaced with a new
one within 2 weeks.
You can find information about ordering a
new filter in chapter „Service" on page EN-17.
Changing the H13 filter (5)
When the "Filter Change Reminder 2" LED
is illuminated, the H13 filter (5) needs to be
changed.
1. Switch off the appliance and take the
mains plug out of the socket.
2. Remove the H13 filter (5) and replace it
with a new filter of the same type (see
"Remove filter packing" on page EN-10).
3. Insert the filter cover (4) at the bottom and
fold it closed.
4. Connect the mains plug to the socket and
switch the appliance back on.
5. Carry out a reset in the manner described
in the "Reset" section on page EN-11.

Changing the Activated Carbon filter (6)

When the "Filter Change Reminder 1" LED
is illuminated, the Activated Carbon filter (6)
needs to be changed.
1. Switch off the appliance and take the
mains plug out of the socket.
2. Remove both filters (see "Remove filter
packing" on page EN-10).
3. Replace the Activated Carbon filter (6)
with a new one of the same type.
4. Replace the two filters.