Troubleshooting Table - hanseatic HAP55055WKC Gebrauchsanleitung

Page EN-16

Troubleshooting table

Troubleshooting table
Malfunctions can occur in all electrical appliances. This does not necessarily mean there is a
defect in the appliance. For this reason, please check the tables to see if you can correct the
malfunction.
WARNING
Risk of electric shock in case of improper repair!
■ Never try to repair a defective or suspected defective appliance yourself. You can
put your own and future users' lives in danger. Only authorised specialists are al-
lowed to carry out this repair work.
Problem Possible cause
ON/OFF button (9) not
pressed.
Mains plug is loose.
Appliance is not
working.
The socket is defective.
The motor is defective.
Appliance is poorly positioned
or air exchange is obstructed.
No purification Filter has not been cleaned/
effect, odours are replaced for a long time.
not adequately
The (new) filter is still in the
removed.
packaging film.
The appliance is placed in
a position where the sensor
cannot adequately measure
The fine dust
the air quality.
display does not
The PM2.5 sensor filter (5) is
change.
dirty.
The Filter Change The Fan Speed button (12)
Reminder was not held down.
LED (11) does
not go out after
changing the filter.
Solutions, tips
Switch the appliance on.
Check that the mains plug is firmly
inserted into the socket.
Try the appliance with a different socket.
Check fuses and/or circuit breakers.
Contact our service department (see
"Service" on page EN-17).
Find another location or remove
obstacles.
Clean filter or change (see "Cleaning the
filter" on page EN-14 or "Changing the
filter" on page EN-13)
Remove the filter and remove the
packaging film. Then insert the filter
again (see "Remove filter packing" on
page EN-9).
Select another location.
Clean the PM2.5 sensor filter (see
page EN-15).
After changing the filter, hold down the
Fan Speed button (12) until the Filter
Change Reminder LED (11) goes out.