Operation; The Display Of Pm2.5 Pollution; The Control Panel - hanseatic HAP40065SWKC Gebrauchsanleitung

Operation

The display of PM2.5
pollution
(9)
888
PM2.5
Turbo
Auto
Sleep
Mode
Power
• Your appliance measures the levels of
particles smaller than 2.5 micrometres in
diameter (PM 2.5) in the indoor air. These
and larger particles are filtered out of the
air by the appliance.
• The particle level is shown in the dis-
play (9). The colour of the display chang-
es from blue to turquoise, green, yellow,
purple and red depending on the amount
of particles. Blue stands for very good air
quality, red for very poor air quality.

The control panel

(7) (8) (10) (11)
888
PM2.5
Turbo
Auto
Sleep
Mode Fan speed
Power
(7) Power:
• This button switches the appliance on and
off. After the appliance is switched on,
a beep will sound and the appliance will
start running at low fan speed.
• To switch off the appliance, press the
power button again.
Low
Middle
High
Fan speed
Reset
Press 5s to
(12)
Low
Middle Filter change reminder 1
High Filter change reminder 2
Reset
Press 5s to reset filter
Operation
(8) Mode:
• Press the button repeatedly to change the
setting.
• Turbo: The filter effect is strongest in this
mode. This setting is recommended for
very bad air, e.g. in smoking areas. The
fan runs at maximum speed here so it is
quite loud.
• Auto: This setting automatically adjusts
the filter effect according to the degree of
air pollution. When the room air is good,
the appliance is barely audible; when the
room air is bad, the fan runs faster and
the volume increases.
The appliance is also equipped with a light
sensor. It adapts the brightness of the LEDs
to the ambient light conditions. In dark con-
ditions, the appliance will automatically be
put into sleep mode and all LEDs will be
switched off. In bright conditions, the appli-
ance will return to normal operation.
• Sleep: Select this setting if you want the
appliance to operate as quietly as possi-
ble, e.g. at night. In sleep mode, all LEDs
are switched off.
(10) Fan Speed:
• By pressing this button repeatedly, you
can select three additional fan speeds:
Low, middle and high.
In total, five different fan speeds can be
set on the appliance using the Mode (8)
and Fan Speed (10) buttons. From lowest to
highest, these are: Sleep/Low/Middle/High/
Turbo.
(11) Reset:
• After a filter change, the corresponding
Filter Change Reminder LED (12) will
light up as before. To switch it off and to
reset the time until the next filter change,
press and hold the reset button (11) for at
least 5 seconds.
Page EN-11