EINHELL TE-SG 18/10 Li Originalbetriebsanleitung Seite 18

In section 10 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger and charging adapter
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.2 Fitting/removing the cartridge holder
(Fig. 4)
Use the fastener (6) to screw the cartridge holder
(7) on the tool. Make sure that the two compo-
nents are securely screwed together.
5.3 Inserting and removing the cartridge
(Fig. 5)
Press the release button (2) and pull the piston
rod slowly to the rear as far as the stop. Insert
the cartridge in the cartridge holder (7). Press
the release button (2) again and push the piston
rod (4) as far as the cartridge. To remove the
cartridge, press the release button (2) again and
pull the piston rod (4) slowly back to the stop. The
cartridge can then be removed from the cartridge
holder (7).
Anl_TE_SG_18_10_Li_SPK13.indb 18
GB
NOTE:
Before you insert the cartridge, check it for punc-
tures or other damage. Use only cartridges that
are undamaged or the tool will become damaged.
If you want to use a cartridge that has already
been opened, fi rst remove all old material resi-
dues.
5.4 Using a cartridge that has already been
used (Fig. 6)
On the cartridge holder is a piercing tool (8). You
can use this tool to pierce holes through dried-up
cartridge nozzles and openings.
5.5 Removing/fi tting the piston rod (Fig. 7-8)
If the piston rod becomes dirty and soiled, it can
be dismantled and cleaned. Proceed as follows:
•
Undo the screw (9) and remove the rod
handle (3) from the piston rod (4) as shown in
Fig. 7.
•
Press the release button (2) and pull the
piston rod (4) forwards and out as shown in
Fig. 8.
To fi t the piston rod, proceed in reverse order.
Please note that the piston rod teeth must point
downwards.
5.6 Battery capacity indicator (Fig. 9/Item e)
Press the battery capacity indicator switch (d).
The battery capacity indicator (e) shows the char-
ge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
- 18 -
09.03.2022 10:22:06