ECTIVE Multiload PRO Bedienungsanleitung Seite 21

• Do not allow metal objects to drop onto or bump against a battery,
as this might produce sparks or short circuit the battery or another
electrical device This could result in a fire or explosion
• Remove any metallic items from your body such as rings, bracelets,
necklaces and watches If such objects come into contact with the
battery terminals, this may cause short circuit currents high enough
to melt the item and cause severe burns
Installation & Charging
• Never charge a frozen battery
• Ensure that the battery is placed in a well-ventilated environment
• Flooded batteries: Check the battery acid levels and add distilled
water to each cell unit if necessary to fill it up to the specified
level This helps purge excessive gas from the cells Do not overfill
the cells Carefully follow the refilling instructions supplied by the
battery manufacturer
• Prior to use, the device must be properly installed as described in
these instructions
• In case of a failure, a battery charger may produce sparks or electric
arcs Therefore, never install the device in the battery or engine
compartment of your vehicle or near any source of explosive gases
• Protect all wiring from physical damage, vibration, water and
excessive heat
• Ensure that the unit is properly set up for the type of battery
intended to be charged
• Do not expose the device to rain, snow or high levels of humidity
• Ensure that all terminating connections are clean and tight to
prevent arcing and overheating
• Do not adjust any functions of the Multiload Pro, including
current, voltage and battery type, while the device is running Any
adjustments must be made when the device is disconnected
ECTIVE Multiload Pro 19