Maintenance And Lubrication - Climber 710 Bedienungsanleitung

In case of uneven ground, humps or dips, the deck should be kept in the highest cutting position to
prevent knocks by the blade.
SLOPING GROUND
If possible, steep slopes must be mown in the up/down direction, taking great care when turning that the
wheels upstream do not strike obstacles (stones, branches, roots, etc.) which might cause the machine
to overturn, or lead to loss of control.
Assess the conditions and take care if the ground and grass are damp since the machine might slip.
Downhill, set off at low speed and do not pass over dry or cut grass since the wheels lose grip.
INTERVENTION OF SAFETY DEVICES
Remember that the engine will stop whenever:
– The operator gets up from the seat.
The engine will not start up if:
– The blade engaging switch is at ON setting (4, fig. 1).
– Nobody is sitting in the driver's seat.
– If the forward lever isn't at STOP setting (2, fig. 3).
CAUTION
Remove the key and disconnect the plug before performing any cleaning, maintenance
or repair operation. Always wear suitable clothing and working gloves.
IMPORTANT!
Protect the environment: carefully dispose of used oils, petrol and any other pollutant product!
Efficient maintenance and correct lubrication help keep the machine in perfect working order.
ENGINE
For the lubrication intervals, follow the instructions provided in the engine handbook; in all cases the oil
must be changed after the first 5 working hours, and then every 50 hours or every season,
together with the oil filter (fig. 12, oil drain plug; please, use a second key in the fixing part).
At every oil change, replace the engine oil filter (fig. 13).
The first precaution is to ensure that the engine is correctly serviced with the air filter, cooling fins and
cylinder head clean and the oil at the correct level.
Check the air filter every 4 hours, or even more often in very dusty environments.
Check the engine cooling intake grille (fig. 4).
HYDROSTATIC AXLE
With the engine cold, check that the expansion tank (fig. 5) is empty.
Clean the hydraulic motor cooling fans often, every 4 working hours in summer when conditions are very
dusty (fig. 5).
Replace oil after the first 50 working hours, then every 200 hours, use 10W60 engine oil; quantity: 1.85
lt. For the replacement follow the instructions given:
1) remove the two plugs fig. 14;
2) remove the plug using a screwdriver fig. 15;
3) screw the two caps fig. 14 (tightening torque 13-17 N.m);
4) add oil, fix the cap fig. 15;
5) make sure the expansion tank is empty, the correct oil level is 12 mm underneath the bottom of
the expansion tank (fig. 6).
FRONT WHEEL AXLE
Grease the wheel pivot pins (fig. 16) every 20 hours.
Lubricate the steering joints.
Climber 7.10 / Translation of the original instructions

MAINTENANCE AND LUBRICATION

9