Barbecook SPRING 3002 Benutzerhandbuch Seite 33

Problem
Yellow flames
Incomplete flame
Flashbacks (flames outside
of venturi tubes/at control
knobs)
Flames higher than edge of
bowl
Pressure regulator buzzing
Burner whistles when set to
LOW
Igniting burner fails
(both with igniter and
match)
Igniting burners fails
with igniter
No sparks or sound when
pressing igniter
Only sound (no sparks)
when pressing igniter
Sparks visible that do not
reach burners
Sparks visible but not
on all electrodes and/or not
powerful enough
Potential causes
• Burners or venturi tubes blocked
• Salt on burners
• Appliance connected to butane
• Burner blocked, pierced, or corroded
• Burners or venturi tubes blocked
• Wind
• Gas bottle (almost) empty
• Fat in bowl and/or on burners
• Warm weather
• New (full) gas bottle
• Gas injector, venturi tube, and/or burner
soiled
• Burner or venturi tube blocked
• No gas supply
• No battery inserted or battery inserted
incorrectly
• Middle burner not ignited first
• Igniter wiring not correctly connected
• Electrode damaged
• Incorrect grounding
• Defective igniter
• No battery inserted or battery inserted
incorrectly
• Battery depleted
• Igniter button not correctly fitted
• Defective spark generator
• Incorrect grounding
• Burner and electrode too far apart
• Defective wiring
• Incorrect grounding
• Battery (almost) depleted
• Wet or defective electrodes
www.barbecook.com
Solutions
• Clean burners and venturi tubes
• Clean burners
• Connect appliance to propane and use a
suitable pressure regulator
• Clean or replace burner
• Close the gas supply and set the burners to
OFF.
• Allow the appliance to cool.
• Clean burners and venturi tubes.
• Turn rear of appliance to wind
• Replace gas bottle
• Clean bowl and burners
• No hazard or fault; stops automatically after
a short period of time.
• Clean gas injector, venturi tube, and burner
• Clean burner and venturi tube
• Open gas supply and press safety button
on pressure regulator (not present on all
regulators)
• Re-insert/insert battery with correct polarity
• Ignite middle burner first
• Check all igniter connections and
re-connect
• Replace electrode
• Check electrodes, burners, and igniter and
re-assemble
• Replace igniter
• Re-insert/insert battery with correct polarity
• Replace battery
• Re-fit igniter button
• Replace spark generator
• Re-connect spark generator and
• electrodes
• Bend electrode slightly to move it closer to
burner
• Replace wiring
• Re-connect spark generator and electrodes
• Replace battery
• Dry electrodes with kitchen paper or replace
electrodes
33