Switching On - Interlogix EasyLock SP1083600 Errichteranleitung

Switching on

The switching on is performed via a 4-pin cable. Two leads are required for the
power supply — nominal 12 VDC. The drive is performed with a static signal 0 V
— active. Additionally an open connector output is available, which switches
approach to 0 V if the locking bolt is extended.
Figure 2: Blocking device connections
Table 1: Inputs and outputs of the blocking device
Signal Lead color
+12 V White
0 V Brown
Input Green
Output Yellow
SP1083600 Motor-Driven Blocking Device EasyLock Installation Manual
Description
Power supply +12 V
Power supply 0 V
Input "Closed"
- 0 V = "Closed"
- open or +12 V = "Opened"
Open collector output, active 0 V: Display of the status "closed"
9