Sluggish Bolt - Interlogix EasyLock SP1083600 Errichteranleitung

In order to provide 3 mm distance between the fixing flange of the blocking
device and the door, different installation housings and counterparts are available
in the range of spare parts for the blocking device.
Figure 9: Breaking point location

Sluggish bolt

If the locking bolt does not extend – due to any reasons whatsoever – it can be
manually screwed out by using a 2.0 to 2.5 mm screwdriver. A slot is provided at
the top of the spindle.
You can indent a corresponding hole at the center of the front face of the bolt
using the corner of the screwdriver. The wall thickness of the bolt amounts to
about 1 mm at this position. After removing the screw cap you can turn the
spindle counter-clockwise using the screwdriver. This way you can unscrew the
bolt.
Figure 10: Locking bolt
14 SP1083600 Motor-Driven Blocking Device EasyLock Installation Manual