Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacing the bolt
If the locking bolt is broken off, you have the option to replace it without
disassembling the blocking device. You need to perform the following steps.
1. Unscrew the screw cap from the housing of the blocking device using the
assembly tools or the bolt replacement (item SP108360S).
The bolt is moved out by activating the SpE input, and can be completely
removed.
2. Set the SpE input on "opened" (i.e. do not activate it any longer).
Now the blocking device will try to move in the bolt.
3. Put the bolt in the correct position to the blocking device — refer to the
drawing below. The two guiding noses on the bolt need to fit exactly to the
guiding grooves of the housing.
After a few seconds the bolt will be moved in.
If you put the bolt the other way around by mistake, it will automatically be
ejected after a few seconds.
After the bolt is correctly inserted, turn in a new screw cap up to the stop.
SP1083600 Motor-Driven Blocking Device EasyLock Installation Manual
15
Werbung
Inhaltsverzeichnis
Fehlerbehebung
