Installation; Assembly Of The Blocking Device - Interlogix EasyLock SP1083600 Errichteranleitung

Installation

The most advantageous installation place is as near as possible to the existing
striking plate of the lock since in this position it will have minimum effects if the
door gets distorted. The blocking device can be installed at any position. The
following devices are required for the installation:
• Wood drill minimum Ø13 mm for the blocking device (optimum Ø13.5 mm to
ease the installation)
• Wood drill Ø13 mm or Ø16 mm for the counterpart
•
Assembly aid (adhesive felt) to position the counterpart (is delivered together
with the blocking device)
•
Ink pad to color the assembly aid (adhesive felt)

Assembly of the blocking device

Produce a hole with a Ø13.5 mm for the blocking device as well as if necessary
an indentation for the cuff in the door frame. Provide enough space for a cable
loop behind the hole for the blocking device or in the further cable duct so that
sufficient cable reserves are available to extend the blocking device for service
purposes.
The installation direction of the flange should be selected preferably in a way that
the power on the bolt will come from the fixing screws of the blocking device –
also refer to Figure 9 on page 14.
The exact installation dimensions are shown in Figure 1 below as well as in the
drilling template (Figure 11 on page 16).
Optionally, there are an installation housing and a counterpart available to mount
the blocking device.
Figure 1: Assembly of the blocking device
(1) Hole Ø 13 for blocking device: Depth about 55 mm
(2) Counter sinking flange: Depth 1.7 mm
6
(1)
(2)
SP1083600 Motor-Driven Blocking Device EasyLock Installation Manual