Product Description; Transport; Technical Data; Installation And Assembly - Dea LOOK 351/SC Bedienungsanleitung Und Hinweise

2 PRODUCT DESCRIPTION

Models and contents of the package
LOOK identifies a family of operators with different characteristics as regards the supply voltage, the reversibility and the presence
of the encoder.
LOOK is designed for installation in residential swing gates, is composed primarily of a mechanical gear motor that drives the lead
screw fastened to the front attachment by means of the adjustment screw.
LOOK is completed by a set of accessories listed in the "PRODUCT ACCESSORIES" table (page 49).
Inspect the "Contents of the Package" (Pic. 1) and compare it with your product for useful consultation during assembly.

Transport

LOOK is always delivered packed in boxes that provide adequate protection to the product, however, pay attention to all information
that may be provided on the same box for storage and handling.

3 TECHNICAL DATA

Motor power supply voltage (V)
Absorbed power (W)
Max Thrust (N)
Duty cycle (cycles/hour)
Maximum n° of operations in 24 hour
Built-in capacitor (µF)
Operating temperature range (°C)
Motor thermal protection (°C)
Opening time 90° (s)
Weight of product with package (Kg)
Protection degree

4 INSTALLATION AND ASSEMBLY

4.1 For a satisfactory installation of the product is important to:
• Verify that the gate complies with the legal requirements and then define the complete project of the installation;
• Verify that the gate is well balanced and that it has no points of friction in opening and closing;
• Identify an area that allows a smooth and safe manual operation of the operator;
• Verify that the operator bulk (Pic. 2) is compatible with the area chosen for the fitting (Pic. 3);
• Use the length/weight graphic and the provided installations dimensions (Pic. 4) evaluating whether you prefer a 90° or higher ope-
ning (Pic. 4).
4.2 Defined and satisfied these prerequisites, proceed to the assembly:
• Fix the rear junction to the pillar bu welding (Pic. 5);
• Fix the front junction to the gate by welding (Pic. 6);
• Keeping the motor in a horizontal position, mount it first to the front bracket, then to the rear bracket (Pic. 7) ensuring that installation
dimensions shown in Picture 4 are respected.
WARNING In order to make the structure sufficiently strong, reinforcement plates to be fixed to attachments may be necessary.
WARNING Grease pins before assembly.
351/SC 355/SC
353/SC -
- 352/SC - - 356/SC -
354/SC
351EN/SC 355EN/SC
230 V ~ ±10% (50/60 Hz)
300
1650
22 - 25 (351EN)
110
8
150
16 12,5 17
9 9,5 9
371/SC -
357/SC -
371EN/SC - 374/SC -
358/SC
- 372/SC 373EN/SC
24 V
60
1200 1000
40
110
10
-20÷50 °C
13,5 14
9,5
IP24
373/SC
371E/SC
50
500
10
50
/
/
15 15
9
9