Sharp PN-HE751 Installationsanleitung Seite 9

Installation
(For SHARP dealers and service engineers)
For box contents, please refer to the Contents on the Index page of this document.
Product warranty does not cover damage caused by improper installation. Failure to follow
these recommendations could result in voiding the warranty.
• This product is for use indoors.
• A mounting bracket compliant with VESA specifications is required.
• Since the monitor is heavy, consult your dealer before installing, removing or moving the
monitor.
• Mounting the monitor on the wall requires special expertise and the work must be
performed by an authorized SHARP dealer. You should never attempt to perform any
of this work yourself. Our company will bear no responsibility for accidents or injuries
caused by improper mounting or mishandling.
• Use the monitor with the surface perpendicular to a level surface. If necessary, the
monitor may be tilted up to 20 degrees upward or downward.
• When installing, removing or moving the monitor, ensure that this is carried out by at
least 4 people (PN-HE651/PN-HC651: at least 2 people.).
• To attach a VESA-compliant mounting bracket, use M8 screws that are 3/8 inch (10
mm) to 1/2 inch (12 mm) longer than the thickness of the mounting bracket.
• This monitor and bracket must be installed on a wall which can endure at least 4 times
or more the weight of the monitor. Install by the most suitable method for the material
and the structure.
• Do not use an impact driver.
• When moving this monitor, be sure to hold it with the handles, the unit sides, the unit
bottom or the unit top. Do not grasp the screen, the AC input terminal on the back of the
monitor, the terminals at the side of the monitor, or the terminals at the bottom of the
monitor. This may cause product damage, failure, or injury.
• If you need to temporarily place the monitor on a table or other surface during
installation, spread a thick soft cloth on the table to prevent damage to the screen and
table.
• After mounting, please carefully ensure the monitor is secure, and not able to come
loose from the wall or mount.
• Do not use any screw holes other than those for mounting brackets, located on the rear
of the monitor, for installation.
3/8 - 1/2 inch (10-12 mm)
Screws (M8)
Mounting bracket
Monitor mounting
7