Sharp PN-HE751 Installationsanleitung Seite 11

3. Connect the supplied power cord
NOTE: • Please make sure that enough power is supplied to the monitor.
• The main power must be turned on/off with the main power switch. Do not
connect/disconnect the power cord or turn the breaker on/off while the main
power switch is on.
• For a complete electrical disconnection, pull out the main plug.
• Connect the power cord to the monitor before plugging it into the power
outlet.
• The power outlet shall be installed near the equipment and shall be easily
accessible.
Cable clamp
For power outlet
Remote control sensor
Be careful not to damage the remote control sensor during installation.
Remote control sensor
PN-HE751/PN-HC861/PN-HC751
Main power switch
(PN-HE751/PN-HC861/PN-HC751)
Main power switch (PN-HE651/PN-HC651)
Remote control sensor
PN-HE651/PN-HC651
9