E-Mode: Set The Emissivity; Max, Min, Dif, Avg - Mode - Wohler IR Temp 310 Bedienungsanleitung

Selecting the measurement mode
Fig. 9: Display after alarm
11.2

E-Mode: Set the emissivity

11.3

MAX, MIN, dIF, AVG - mode

38
IRT – Tamb > 5,75 °C or < -5,75 °C:
or
The buzzer and optional vibration func-
tions will start at the same time.
According to the following value, "CHK"
(check) is displayed beside the THB mode
icon. In this case please continue to ob-
serve.
The bar colour changes according to the
Temperature:
4,25 °C < IRT – Tamb < 6,5 °C: red
- 3,5 °C ≤ IRT – Tamb < 4,25 °C: yellow
- 6,5 °C < IRT – Tamb < -3,5 °C: blue
Default emissivity: 0,95
The emissivity can be changed from 0.10
(10E) to 1 (100E).

In E-Mode press Mode key.

Then press Up key or Down key to
set the emissivity.

Press Mode key again to confirm.
NOTE!
An external surface temperature sensor
can be connected to check whether the
emission factor is set correctly. If the IR
temperature and surface temperature
match, the emission factor is correct.

Press Mode key for the Maximum
(MAX), Minimum (MIN), Difference
between MAX and MIN (DIF) and Av-
erage (AVG) modes. During the
measurement, the special modes
reading will be displayed beside the
mode icon.