Switching The Laser Beam On/Off; Infrared Temperature; Selecting The Unit; Selecting The Measurement Mode - Wohler IR Temp 310 Bedienungsanleitung

Switching the laser beam on/off

8 Switching the
laser beam on/off
9 Infrared tempera-
ture
Fig. 5: Surface temperature
10

Selecting the unit

11 Selecting the
measurement
mode
11.1 THB – Thermal bridge detection
THB: thermal bridge detection
36

To switch the laser beam off
and on again during the
measurement, keep the
measurement key pressed
and simultaneously press the
down key.

Keep the measurement key
pressed.
The surface temperature in the
selected unit (°C or °F) appears in
the middle of the display.

Press the °C/°F key to switch
between the units.
You can switch between the units
at any time.
Exception: It is not possible in the
mode for setting the emission
value (E) and the alarm limits
(HAL and LAL)

Press the mode-key to switch
between the modes.
When the device is switched off
and on again, the last mode
called up is activated.
In THB Mode the temperature
differences between wall and room
temperature is shown. Critical
areas where thermal bridges occur
are indicated with a colour bar and
a house symbol. The colours
change according to the following
illustration, depending on whether
the wall or ambient temperature is
higher.