Retevis RM20 Bedienungsanleitung Seite 18

CE Requirements:
•(Simple EU declaration of conformity) Shenzhen Retevis Technology Co., Ltd. declares that the radio equipment type is in compliance with
the essential requirements and other relevant provisions of RED Directive 2014/53/EU and the ROHS Directive 2011/65/EU and the WEEE
Directive 2012/19/EU; the full text of the EU declaration of conformity is available at the following internet address: www.retevis.com.
•Restriction Information
This product can be used in EU countries and regions, including: Belgium (BE), Bulgaria (BG), Czech Republic (CZ), Denmark (DK),
Germany (DE), Estonia (EE), Ireland (IE), Greece (EL), Spain (ES), France (FR), Croatia (HR), Italy (IT), Cyprus (CY), Latvia (LV),
Lithuania (LT), Luxembourg (LU), Hungary (HU), Malta (MT), Netherlands (NL), Austria (AT), Poland (PL), Portugal (PT), Romania (RO),
Slovenia (SI), Slovakia (SK), Finland (FI), Sweden (SE) and United Kingdom (UK).
For the warning information of the frequency restriction, please refer to the package.
•Disposal
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that in the European Union, all
electrical and electronic products,batteries, and accumulators (rechargeable batteries) must be taken to designated collection
locations at the end of their working life. Do not dispose of these products as unsorted municipal waste. Dispose of them
according to the laws in your area.
IC Requirements:
Licence-exempt radio apparatus
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
•Occupational/Controlled Radio, this radio is designed for and classified as "Occupational/Controlled Use Only", meaning it must be used
only during the course of employment by individuals aware of the hazards, and the ways to minimize such hazards; NOT intended for use in
a General population/uncontrolled environment.
•General population/uncontrolled Radio, this radio is designed for and classified as "General population/uncontrolled Use".
To control your exposure and ensure compliance with the occupational/controlled environment exposure limits, always adhere to the
following procedures. When operating in front of the face, worn on the body, always place the radio in a Retevis approved clip, holder,
holster, case, or body harness for this product. Using approved body-worn accessories is important because the use of Non-Retevis
approved accessories may result in exposure levels, which exceed the IEEE/ICNIRP RF exposure limits.
(listen), release the PTT button. Transmitting necessary information or less, is important because the radio generates measurable RF
energy exposure only when transmitting in terms of measuring for standards compliance.
•DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed RF
exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or an antenna specifically authorized by the
manufacturer for use with this radio, and the antenna gain shall not exceed the specified gain by the manufacturer declared.
to be exceeded.
•During transmissions, your radio generates RF energy that can possibly cause interference with other devices or systems. To avoid such
interference, turn off the radio in areas where signs are posted to do so.
•DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation such as hospitals, aircraft, and blasting sites.
•Portable Device, this transmitter may operate with the antenna(s) documented in this filing in Push-to-Talk and body-worn configurations.
RF exposure compliance is limited to the specific belt-clip and accessory configurations as documented in this filing and the separation
distance between head and the device or its antenna shall be at least 2.5 cm.
•Mobile Device, during operation, the separation distance between user and the antenna subjects to actual regulations, this separation
distance will ensure that there is sufficient distance from a properly installed externally-mounted antenna to satisfy the RF exposure
requirements. Transmit only when people outside the vehicle are at least the recommended minimum lateral distance away from a properly
installed according to installation instructions, externally mounted antenna.
FCC RX exposure compliance
Hand-held Mode(if applicable)
• Hold the radio in a vertical position with the microphone (and other partsof the radio including the antenna) at least 2.5 cm
(one inch) away from the nose or lips. The antenna should be kept away from the eyes. Keeping the radio at a proper
distance is important as RF exposure decreases with increasing distance from the antenna.
Phone Mode(if applicable)
•When placing or receiving a phone call, hold your radio product as you would a wireless telephone. Speak directly into the microphone. Do
not use the equipment when you are driving
Electromagnetic Interference/Compatibility
NOTE: Nearly every electronic device is susceptible to electromagnetic interference (EMI) if inadequately shielded, designed, or otherwise
configured for electromagnetic compatibility.
Avoid Choking Hazard
Small Parts. Not for children under 3 years.
15