Child Safety Lock; Use - clage Zip HydroTap G5 BCS 20 Gebrauchs- Und Montageanleitung

5. Use

Boiling, chilled,
sparkling water Mains water
SELECT
SAFETY
Zip lever Mixing lever
Safety button
Arc / Celsius Arc
Select the desired type of water by tipping to on the Select button on the ZIP lever at
the tap.
• Red: boiling water
• Blue: chilled water
• White: sparkling water
Turn the lever to dispense water. When the lever is turned counterclockwise, water will
flow as long as the lever is held (max. 15 sec.). If the lever is turned clockwise, water
will flow continually for 5 to 15 seconds. This time can be set in the menu. The lever
then has to be manually returned to the Off position.
Note: When dispensing water at the Celsius Arc tap, pay attention to the orienta-
tion of the swivel spout.
Dispense mains water (Celsius Arc)
To dispense mains water, use the mixing lever of the tap.
Pull the lever to the side to open the valve.
Rotate forward or back to dispense cold, warm or mixed mains water.
Note: When dispensing water, pay attention to the orientation of the swivel
spout.
Red light (Arc / Celsius Arc / Classic Plus / Classic)
• On all the time: boiling water is ready and can be dispensed.
• Flashing: the water has not yet been heated to the set temperature.
Blue light (Arc / Celsius Arc / Classic Plus / Classic)
• On all the time: temperature of chilled water is at the set temperature.
• Flashing: the water has not yet been chilled to the set temperature.
White light (Arc / Celsius Arc / Classic Plus)
• On all the time: temperature of sparkling water is at the set temperature.
• Flashing: the water has not yet been chilled to the set temperature.
White filter LED (Classic)
• Flashing: the filter needs to be replaced. This LED starts flashing according to filter
use and the filter capacity set in the menu.
Note: For the taps Arc and Celsius Arc the need for a filter replacement is indi-
cated by cyclically flashing all the LEDs in all three colours

Child safety lock

Classic / Classic Plus
A child safety lock can be enabled to prevent boiling water flowing out of the tap if the
red lever is accidentally operated. To dispense boiling water when the child safety lock
is enabled, press the Safety button and the red lever at the same time.
The child safety lock can be enabled and disabled either under Settings/Safety in the
menu or directly on the tap, as described below.
To enable the child safety lock, press the Safety button and the blue cold water lever at
the same time and hold for about ten seconds. The Safety button lights up when the
child safety lock is enabled.
To disable the child safety lock, press the Safety button and the blue cold water lever at
the same time and hold for about ten seconds. The Safety button light goes out when
the child safety lock is disabled.
33
CLAGE
EN