After Use - Scott Safety PROFLOW 2 SC 160 Bedienungsanleitung

AFTER USE

Stop the blower device by depressing the power button.
Doff the unit. Carry out the necessary maintenance for the blower device and recharge the battery.
Decontamination
In applications where this equipment is exposed to or in contact with a hazardous material,
national or local regulations specific to that material must be followed when decontaminating
the equipment before cleaning and maintaining it.
Under shower
No need to detach any components.
Stop the blower device.
Filters face down. Do not spray water into the filters (air channel).
Filters must always be replaced after shower-cleaning.
After showering during exit procedures and before further cleaning of the blower, disconnect
the hose and seal the blower outlet and remove the filters and seal the blower inlets, using
the screw caps provided. Take care during this operation to prevent materials entering these
areas.
Cleaning
Clean with a damp cloth or sponge. When necessary, a ready-for-use device (breathing hose
connected) can be cleaned under shower, with the filters facing down. Do not spray water
into the filters. Filters must be replaced after shower-cleaning.
Do not use solvents (e.g. acetone, turpentine). Never clean with compressed air or compressed water.
Storage & Transportation
The Device must be protected from damage during transportation. Store protected from direct sunlight, at
-10...+30 °C and relative humidity (RH) under 75 % (sealed filters RH max. 95 %).
Interim recharging
Deep discharge of the battery during long-term storage can be prevented by keeping the blower device on
recharge.
However, if standby charging is unpractical, batteries can be interim-recharged e.g. three times a year. Prior
to use, at least one cycle of discharge and charge should be carried out.
Obsolescence
Refer to product marking and packaging.
DISPOSAL
Dispose of the components in accordance with local regulatory requirements. A very contaminated blower
device as well as used filters are special refuse and shall be disposed of according to the filtered substances
(gases or particles). Dispose of the battery in accordance with WEEE and all applicable regulations.
The crossed-out wheeled bin symbol shown on this product, packaging or instructions indicates the product
is subject to European Community Directive 2012/19/EU on correct handling of Waste Electrical and
Electronic Equipment (WEEE).
WEEE cannot be disposed of as municipal waste and must be collected and disposed of separately.
Appropriate waste collection systems defined by national regulations should be used.
For more information, please contact the company where you purchased this product or visit www.
scottsafety.com
16
Proflow 2 SC 160 Asbestos Issue G