Technical Data Charger And Battery (B); Function Of The Unit; Overview (A); Working Notes - Rothenberger Rocam Mini Hd Bedienungsanleitung

Slide cable diameter ....................... ø 7.0 mm
Working range ................................ Ø 40 - 110 mm
Positioning transmitter ....................... 33 kHz
Protection class camera head ............ IP 68
Included in delivery: ROCAM mini HD TV- inspection system with Camera head ø25 mm, guide
ball, USB cable, test adaptor, manual, SD card, battery and charger.
3 Technical Data charger and battery
Battery:
U = Voltage
C = Capacity
W = Weight
Ic = Charge current
t = Approx. charging time (90% full)
Charging voltage.............................
Charging temperature .. 0° - 50° C, 32° - 122° F
Max. discharging
temperature. ................................
Recharge battery pack before first use!
4

Function of the Unit

4.1 Overview
Camera head
1
Positioning probe
2
Bending spring
3
Reel cable
4
Monitor unit
5
Reel
6
4.2

Working notes

- Do not bend the reel cable! The cable may break!
- Do not pull the reel cable over sharp edges! The cable may become damaged!
ATTENTION! Always protect ROCAM mini HD against water, and use only recom-
mended indoors. Only the camera head (1) and reel cable (4) may come into contact
with water!
4.3

Changing the battery

 Insert the battery into the receptacle on the back of the frame (7) until it clicks into place. To
remove, press the battery release (11) and pull the battery out.
4.4

Working with the device

Wear protective clothing! Always stand next to the reel cable!
 Push reel cable (4) with bending spring (3) from the holder (8).
 Remove the cap from the camera head (1) and screw on the bending spring (3).
Caution: Check for cleanliness and damage!
 If necessary, additional accessories can be attached to camera. When using pipe diameters
greater than 70 mm, always use guide body!
 Clean the pipe system before inspection.
20
20,75 V DC
5° - 50° C, 41° - 122° F
ENGLISH
Charger:
U1 = Input voltage
f1 = Input frequency
P1 = Input power
U2 = Charging voltage
I2 = Max. charge current
Nc = No. of battery cells
W = Weight
Pay attention to the electrical outlet
voltage! Check the label on the
bottom of the charger!
Frame
7
Holder
8
Monitor cable
9
Monitor bracket
10
Battery release
11
Battery
12
(B)
(A)