Automatic Programs; Ambient Lighting; Timer Function - Beurer FB 65 Gebrauchsanweisung

Automatic programs

The foot bath has one preset and three individually selectable programs:
PO = Manual operation / Program OFF (default)
P1 = Bubble and vibration massage on simultaneously for 10 seconds and pause for 5 seconds
P2 = Bubble massage and pulsating vibration alternating for 15 seconds each
P3 = Bubble and vibration massage alternating for 10 seconds each
1. Select the desired program (P1, P2, P3) using the "Programs" function button
button starts to light up. The currently set program is briefly displayed on the LED touch display
16
The display switches back again to the water temperature.
2. To change to manual mode, press function button
. The function button
Bubble massage
You can switch a bubble massage on during use.
1. To switch the bubble massage on, press the "Bubble" function button
starts to light up.
2. To switch the bubble massage off again, press function button

Ambient lighting

You can switch ambient lighting on during use.
1. To switch the ambient lighting on, press the "Ambient lighting" function button
button and the light strips in the foot bath begin to light up.
18
2. Use function button
• Red light can increase circulation and stimulate metabolism.
• Green light can have a balancing effect and increase the recovery factor.
• Blue light supports relaxation and can have a harmonising effect.
• Yellow light can generate positive energies and increase optimism.
• Purple light can put the body in an improved meditative mood and be inspiring.
• Turquoise light can have a calming and cooling effect on the body and is particularly recommended
with cold water.
3. To switch the ambient lighting off, either press and hold function button
function button
18
out after the turquoise light.

Timer function

You can set a timer time of between 20 and 60 minutes (in 5-minute increments) on the foot bath. After this
time has passed the foot bath switches off automatically. Initially, the timer time is automatically preset to
20 minutes.
1. Use the "Timer" function button
briefly in the water temperature / timer time display
2. You can display the remaining relaxation time during use by pressing function button
3. If function button
20
4. As soon as the relaxation time has elapsed, the foot bath automatically switches to standby mode.
LED turns off.
16
to select the desired ambient light (red, green, blue, yellow, purple or turquoise).
18
repeatedly until the LED of function button
to select your desired relaxation time. The selected timer time is shown
20
is pressed several times during use, the relaxation time is restarted.
again until PO appears in the LED touch display
16
17
again. The LED turns off.
17
and the light strips in the foot bath go
18
before the water temperature is displayed again.
19
18
. The LED of function
16
. The LED of function button
. The LED of function
18
for two seconds or press
18
once.
20
.
1
1
17