Battery Installation - Viper AS5160 Schnellstartanleitung

QUICK START GUIDE

Battery installation

1. Open the recovery tank cover (1) and check that the recovery tank (25) is empty; otherwise empty it with the
drain hose. (22)
2. Close the recovery tank cover (1).
3. Overturn the recovery tank (25) carefully.
4. The machine is supplied with cables suitable to install 2X12V batteries. Carefully put the batteries into the com-
partment, then install them correctly.
5. Route and install the battery cable as shown in (Figure 3), then carefully tighten the nut on each battery terminal.
6. Place the protection cap on each terminal, then connect the battery connector (54).
7. Carefully lower the recovery tank (25).
BRUSH/PAD-HOLDER INSTALLATION AND UNINSTALLATION (only for disc machine)
NOTE
Install either the brush (A, Figure 5) or pad-holder (B and C, Figure 5) according to the type of
floor to be cleaned.
CAUTION
Before installation or uninstallation of brush or pad-holder, make sure all the switches on ma-
chine are in off position and lifting the squeegee from the floor. The operator must be equipped
with suitable personnel protection devices, such as gloves to reduce the risk of accidents.
Proceed as following:
1. Insert the ignition key (35) and turn it to "O".
2. Lift the deck by pressing the pedal (9).
3. If equipped, turn the speed adjuster (40) to idle by
turning it counter-clockwise.
4. Place the brushes (A, Figure 5) or the pad-holder (B)
under the deck (21).
5. Lower the deck on the brushes/pad-holders by pressing
the pedal (9).
6. Turn the ignition key (35) to "I".
7. Brush/pad-holder and vacuum system switch (46).
8. Press one of the Brush/forward gear switch (34) to
engage the brush/pad-holder, then release it. If necessary,
repeat the procedure until the brushes/pad-holders are
engaged.
9. If Step No.8 above proves to be difficult, use the manual
method by turning the brush/pad-holder in the direction
opposite to the normal turning direction, and it can be
taken off. (as shown in Figure 5)
WARNING!
(Only for machine with traction) Turn the
speed adjuster (40) counter-clockwise to
drive the machine at the minimum speed.
Slightly press the switch (34), otherwise the
machine starts to move.
To engage the brush/pad-holder press the switch
(34) which turns on the brush/pad-holder motor.
10. To remove the brush/pad-holder lift the deck by pressing
the pedal (9), then press the switch (44), the brush/pad-
holder will be remove.
!
11
ENGLISH
A
C
Figure 5
Figure 5.1
B