Parts And Components; Before Use; Operation - cecotec FUN PIZZA&CO MAKER Bedienungsanleitung

1. PARTS AND COMPONENTS

Fig. 1
Fig. 2
1. Upper housing
2. Decorative plate
3. Non-stick upper plate
4. Non-stick lower plate
5. Lower housing
6. Timer knob
7. Operation indicator light (Green)
8. Temperature knob

2. BEFORE USE

Take the product out of the box.
Make sure all parts and components are included and in good conditions. If any visible signs
of damage are observed, contact Cecotec's Technical Support Service immediately. Keep the
original box.
Before using the appliance for the first time, remove any packaging materials, stickers or
protective foil.
Use a dampened soft cloth with warm water to clean the non-stick plates.
Dry it with a dry cloth or paper towel.
For optimum results, grease the non-stick plates with a teaspoon of vegetable oil and spread
it with kitchen paper and wipe any excess of oil.
Warning: A strange odour and smoke might appear during the first use due to manufacturing
wastes. This does not affect the safety or the operating of the appliance.

3. OPERATION

Preparing the device for usage
Connect the device to a power supply and close it.
Pre-heat the device by setting the temperature knob to its maximum level and setting the
timer to its maximum time. Turn both knobs fully clockwise.
The red power indicator light and the green light indicator will turn on, indicating that the
device has started pre-heating. It will take approximately 5 minutes to reach the temperature
for baking. The red light will remain switched on until you unplug the device. When a green light
switches off, this means that the device is ready for being used.
Introduce the pizza and set the desired cooking time according to your likings.
04278_Fun Pizza&Co_Manual_YV01200422.indd 23 04278_Fun Pizza&Co_Manual_YV01200422.indd 23
ENGLISH
23
FUN PIZZA&CO MAKER
22/4/20 18:19 22/4/20 18:19