CNA HPS 844N Bedienungsanleitung Seite 23

Function Easy Valet
This is always the VALET function but changes the activation mode (simpler) if the ignition key is not present in
the vehicle, but the START & STOP button.
Activating and deactivating the Easy Valet function:
• ignition key on, front doors closed and alarm off, press the programming button for about 10 seconds, the
LED blinks quickly
• Release the button before the LED turns off.
If the function is enabled -> 1 flashing arrows - 1 beep - 1 LED flashing
If the function is disabled -> 2 flashing arrows - 2 beeps - 2 flashing LEDs
Each time the vehicle is switched on, 2 LED flashes (for 40 sec.) Indicate that the function is switched on.
Use of pin code for release
To be used when the remote controls are lost or no longer operating when the alarm system is still
armed.
The code is always made of 3 digits (factory setting: 1-2-3). This code should be composed (when the
alarm is armed) with the ignition key:
1. Turn the ignition key ON/OFF until you have reached the first digit (e.g. 1 in case of factory setting)
The LED is illuminated while composing the pin code and the horn or the siren sounds.
Wait until the LED extinguishes.
2. Turn the ignition key ON/OFF until you have reached the second digit (e.g. 2 in case of factory
setting)
3. Wait until the LED extinguishes.
4. Turn the ignition key ON/OFF until you have reached the third digit (e.g. 3 in case of factory
setting)
If you succeed, the alarm system will disarm after the third digit.
Modification of the release pin code
You may ustomize the factory pre-set release pin code (1-2-3) just following the herewith procedure,
alarm disarmed:
1. Through the ignition key compose the old secret code as described in the previous paragraph.
2. Wait for the quick flashing LED of confirmation that the old code of unblocking is correct.
Wait until the Led extinguishes.
3. Turn the ignition key ON/OFF until you have reached the first value to be modified.
The LED will illuminate during the composition of the secret code.
Wait that the LED on the dashboard extinguishes.
4. Turn the ignition key ON/OFF until you have reached the second value to be modified.
Wait that the LED on the dashboard extinguishes.
5. Turn the ignition key ON/OFF until you have reached the third value to be modified.
Wait that the LED on the dashboard extinguishes
If you succeed, the quick flashing of the LED on the dashboard confirms that the new secret code
has successfully substituted the old one.
THE NEW PIN CODE WAS STORED AND HAS SUBSTITUTED THE OLD ONE
INSERT HERE THE NEW PIN CODE
HPS 844N rev.02 09/17 pag. 23 di 48