Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
button N° 2 of the HPA 974 remote control.
It is possible to exclude the PANIC function, look at the list "PROGRAMMABLE FUNCTION".
Volumetric module Hps 55 and infrared Hpa Irl exclusion
After the system arming, press the LOCKING push-button of the original remote control or the button
N°3 of the HPA 974 remote control within 5 seconds. The exclusion will be confirmed by 3 bip and 3
blinkers flashes. Or press the close button on the original remote control, within 5 seconds, press the
open button on the original remote control, within 5 seconds press the close
button on the original remote control.
Adjustement ultrasonic module Hps 55 (optional)
Ultrasonic sensitivity may be adjusted by using the trimmer in the
module. Rotate the trimmer clockwise to increase sensitivity and anti
clockwise to decrease it. Warning: an incorrect adjustment may cause
false triggering of the alarm.
Through the ignition key it is possible to exclude the functioning of the horn or the siren.
With the alarm disarmed (CDL opened), turn on and off the ignition key for 3 times and, within 30
seconds, press the original remote control to close the CDL of the vehicle.
At the insertion of the antitheft and within the neutral time of 10 seconds press the key 2 of the HPA
974 remote control.
From this moment, the central unit will signal the attempt to break in by the flashing of the blinkers
only.
With this function it's possible to control if the vehicle is closed.
Contemporaneously press the button N°3 and N°1, if the vehicle is closed the LED of the HPA 974
remote control flash for some seconds, but if the LED stay OFF it means that the vehicle is not closed.
ATTENTION: this function is able only if the vehicle was closed trough the HPA 974 remote control.
L
o
L
o
If during the system arming and disarming by the HPA 974 remote control it doesn't give the
acoustic signal means that the battery is discharged. This function is available if the base settings
about the bip on arming and disarming was not modified (look at the programming list)
BATTERY REPLACEMENT: Open the remote control box, extract the old battery and insert the new
one. Respect the polarity that is showed on the battery seat. Use the lithium battery CR 20-32.
It's recommended to replace the battery every 2 or 3 years.
If the alarm system notes some radio disorders, it gives an alarm cycle. Feature disabled by default.
If the central unit records one or more causes of alarm, they are signaled, when disarming and open
the driver door or press the programming button through the LED. To verify the type of alarm,
Siren exclusion
Central door locking command
w
b
a
t
t
e
r
y
H
p
a
9
7
4
r
e
m
o
w
b
a
t
t
e
r
y
H
p
a
9
7
4
r
e
m
o
Jamming function
Alarm memory
HPS 844N rev.02 09/17 pag. 20 di 48
Ultrasonic Adjustement
HPS 55
t
e
c
o
n
t
r
o
l
t
e
c
o
n
t
r
o
l
Werbung
Inhaltsverzeichnis
