Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11
12
13
14
15
16
17
18
19
22
23
24
25
26
28
29
30
31
This function puts the alarm in stand-by mode. This allows the car to be left at a service center
without leaving the remote control.
Activation of the Valet function:
Compose, using the ignition key, the unlocking
code (factory setting 1-2-3)
If the operation is successful, the LED on the
dashboard will flash twice
To remind that the Valet function is active the LED on the dashboard will flash twice at any time one
turns on the ignition key.
Enable/Disable opening impulse with original remote control (purple
wire).
Set 30 seconds/1 second locking pulse (1sec default)
Set double/single locking pulse (single default)
Set double/single unlocking pulse (single default)
Set the blinker flashing, when arming/disarming the system by the
HPA 974 remote control, ON/OFF (ON default)
Anti distraction ON/OFF (OFF default)
Disarm alarm with the third button of the original remote control
ON/OFF (ON default)
Panic alarm ON/OFF (ON default)
Set all beep OFF/ON White wire horn (bip ON default)
Set mode SIREN/HORN during the alarm cycle (HORN default) wire
White
Jamming function ON/OFF (OFF default)
Original remote control operation ON/OFF (ON default)
Comfort permanent ON/OFF (OFF default)
Alarm switch-off with the +15 CAN ON/OFF (OFF default)
Centralized automatic door closure when exceeding 10 km/h ON/OFF
(OFF default)
HPA 974 remote control deletion
Transmitters deletion
Restore standard alarm setting
F
u
n
c
t
i
o
n
V
a
l
e
t
F
u
n
c
t
i
o
n
V
a
l
e
t
Deactivation of the Valet function:
Compose using the ignition key the unlocking
code (factory setting 1-2-3)
If the operation is successful, the Led will flash
twice and all the system functions will be
restored.
HPS 844N rev.02 09/17 pag. 22 di 48
Werbung
Inhaltsverzeichnis
