Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Self powered siren installation Hps 94 (optional)
The siren must be installed into the engine compartment, it is equipped with internal battery that
permit to the siren to sound when the power supply wires are cut.
Magnetic sensors 2.4 GHz Hpa 975 installation (optional)
It is possible to install the 2,4 GHz transmitters on door and windows.
Put the transmitter on the fixed part and the magnet on the mobile part (door or windows), as showed
in the picture.
BATTERY REPLACEMENT: Open the box transmitter, extract the PCB, take out the old battery and
insert the new. Respect the polarity that is showed on the battery seat. Use the lithium battery CR 20-
32.
It is recommended to replace the battery every 2 or 3 years.
F
u
n
F
u
n
Every time that the Magnetic Sensor and Remote Control will be used, the alarm gives an answer
signal of aknowledgement, that shows the device recognition to stop the signal transmission. The
transmission is bidirectional.
It is showed by LED signalization:
- Fixed : the transmission is good, the transmitter is recognized;
- Fast flashing: the transmission is not good, too much distance from the alarm system, or sensor
is not memorized;
- 4 slowly flashing: battery discharged.
Memorizing of the magnetic sensors
• Magnetic sensors memorizing
- Push the programming button 3 times, the LED flashes fast;
- During the LED flashing turn ON the magnetic sensor to memorize;
- The correct memorize is indicated by a bip, a flash lamp and the 1 second LED ON.
Repeat the procedure for each magnetic sensor to memorize.
The procedure can stop after 30 seconds from the last memorization or after turning ON the key.
The maximum number of the devices accepted in the area 1 is 24.
c
t
i
o
n
o
f
M
a
g
n
e
t
i
c
S
e
n
s
o
c
t
i
o
n
o
f
M
a
g
n
e
t
i
c
S
e
n
s
o
HPS 844N rev.02 09/17 pag. 17 di 48
r
H
p
a
9
7
5
r
H
p
a
9
7
5
Werbung
Inhaltsverzeichnis
