Panic Alarm - CNA HPS 844N Bedienungsanleitung

Hpa 974 remote control operating
With HPA 974 remote control, it's possible to simulate the same original remote
control operation with some plus functions.
S
YSTEM ARMING
Push the button N°3 of the HPA 974 remote control. Arming:
- 1 bip
- The LED on the dashboard turn ON;
- CDL locking (if connected)
- Engine block ON (if connected)
- Modules output arming (windows module, ultrasonic, etc..)
S
YSTEM DISARMING
Push the button N°1 of the HPA 974 remote control. Disarming:
- 2 bip
- The LED on the dashboard turn OFF;
- CDL unlocking (if connected);
- Engine block OFF (if connected);
- Modules output disarming (ultrasonic, etc..)
Once the signalling of arming is over, the alarm will stay for 10 seconds in "neutral time" condition,
signalled by the fixed light of the LED. The flashing of the LED of the dashboard will indicate that the
system supervises the vehicle and is ready to signal the alarms.
Alarm cause during the neutral time
If the alarm system notes a cause of alarm during the neutral time of 10 seconds, it is shown through
the blinker flashing (the number of the blinker flashing indicates the cause of alarm, as shown in the
table in the chapter "alarm memory"). If the alarm notes the same cause of alarm for 3 times, it gives
an alarm cycle.
In case of attempt to brake in, the system will emit an optic-acoustic signal (flashing of the blinkers
and sound of the siren), repeated for 30 seconds.
To stop the alarm signal without disarming, press the LOCKING button of the original remote control
or the button N°2 of the HPA 974 remote control.
To stop the alarm signal and disarming, press the OPENING button of the original remote control or
the button N°1 of the HPA 974 remote control.
Alarm armed , 10 second after arming, press the LOCKING push- button of the original remote control
or the button N° 2 of the HPA 974 remote control: central unit will do an alarm cycle of about 30
seconds.
To stop the alarm cycle press again the LOCKING push- button of the original remote control or the
:
Neutral time and alert status
Alarm

Panic alarm

HPS 844N rev.02 09/17 pag. 19 di 48