Tensioning The V-Belt; V-Belt Change; Tool Exchange - HOLZMANN-MASCHINEN FS160SOLID Betriebsanleitung

17.2.2 Tensioning the V-Belt

1. Open the door (1) to get access to the V-Belt drive.
2. Loose fixation lever (B) and adjust correct belt-tension with Lever (A).
Sufficient belt tension is achieved when the belt yields approx. 10 mm when
loaded with approx. 20N (2 kg). Please make sure that the belt is not over-
tensioned.
3. When belt-tension is correct fix the fixation lever (B) and close the door (1)
again.

17.2.3 V-Belt change

1. Open the door (1) to get access to the V-Belt drive.
2. Fully loosen the belt-tension.
3. Lift the belt (2) from the drive roller (3) and replace it with a new one.
4. Adjust /Check correct V-Belt tension and assemble cover (1) again.

17.2.4 Tool exchange

Before any manual tool change, stop the spindles, wait for all tools to come to a
standstill and prevent unintentional restart.
Tools are razor-sharp for protection when changing tools wear gloves and observe
proper handling of tools so that damage to the cutting surfaces is prevented (no
storage on a metal surface only in special boxes).
HOLZMANN MASCHINEN GmbH
C A U T I O N
C A U T I O N
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
1. Move the spindle the max. uppermost
position.
2. Release the protective hood lock (A) and flip
the protective hood (B) up.
3. Engage spindle lock.
4. Release the fixing and slide the fences
towards each other to gain access to the
cutter/spindle.
36
FS160SOLID