Adjustment Down Holds; Adjustment Fence; Application Note; Working At The Fence (Milling Of Long Sides And Profiles) - HOLZMANN-MASCHINEN FS160SOLID Betriebsanleitung

16.2.5 Adjustment down holds

16.2.6 Adjustment fence

The fence part (E) and fence part (A) can be adjusted in their position relative to each other.
For this purpose:
1. Select the appropriate working position for the selected cutter using the screws (1).
There are 2 positions available on the worktable.
2. Loosen the clamping screw (2) and set the desired position of the fence with the knob
(3) and then fix the clamping screw (2) again.

16.3 Application note

16.3.1 Working at the fence (milling of long sides and profiles)

When performing this operation, the following equipment must be used for safe work:
 the fence
 the cross-cut fence, if necessary
 the protective hood
 the hold downs (table,fence)
 the inlays in the table
 push stick, sliding wood for guiding the workpiece
Long sides:
Additional settings required before commissioning:
- Set the fence (A) exactly to the cutter's flying circle.
- Set the required chip removal with the fence (E).
- Press the workpiece against the fence and the table and guide it past the tool. Ensure that all body
parts, especially the fingers, are at a sufficient distance from the tool.
Profiles:
- Set the required chip removal by means of the fence (E) and align the fence (A) exactly with the
fence (E) .
- Press the workpiece against the fence and the table and guide it past the tool. Ensure that all body
parts, especially the fingers, have sufficient clearance from the tool.
Switch off the machine after completion of the operation.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
The down holds can be shifted in the vertical
(2) and horizontal (1) position on the rods,
allowing them to be adapted to the workpiece
to be machined.
OPERATION
34
FS160SOLID