HOLZMANN-MASCHINEN FS160SOLID Betriebsanleitung Seite 30

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
3. Locking the cover
To lock the cover, release the lock
button (1), slide the clamp away
from the center of the hood so
that the tongue is under the hood,
and retighten the lock button (1).
Repeat the same procedure on the
other side.
This cover MUST be closed and locked
when the machine is in operation.
4. Assembly fence
Loosen the fixing screw of the
fence depth adjustment and the
fixing screw of the fence width
adjustment. Slide the fence over
the fixing plate so that the mitred
end of the stop is in the middle of
the hood.
Screw the fence firmly to the hood
using the adjusting screw. After
completing the adjustment work,
lock both fixing screws to hold the
fence in position.
5. Assembly hold down (table):
Insert the rectangular bar (1) into
the protective hood cover and lock
it with the thumbscrew. Insert the
pressure plate (3) between the
thumb screw and the rectangular
bar (1) and slide the table
pressure shoe (2) onto the
rectangular bar (1) and secure it
with the thumb screw.
6. Assembly hold dowwn (fence)
Assemble the fence hold down (5)
on the rectangular bar using the
two screws (6) as shown. Remove
the screw (7), insert the pressure
plate (3) between the thumb
screw and the rectangular bar (4)
and slide the milling fence hold
down (4) onto the rectangular bar
ASSEMBLY
30
FS160SOLID