Safety Warning; Warnings For The Installer - Palazzetti ELSA NEW Installations- Und Wartungsanleitung

2

SAFETY WARNING

2.1

Warnings for the installer

Observe the prescriptions contained in
this manual.
The instructions for assembly
and disassembly of the appli-
ance are reserved for specialist
technicians only.
The installation, use and maintenance
of the product must be in accordance
with the manufacturer's instructions
and in compliance with the regulations.
Failure to comply with the instructions
and any incorrect operations may give
rise to hazardous situations, damage to
property, animals, health problems or
malfunctioning.
Installation, functional testing and
maintenance should only be carried
out by authorised, qualified personnel.
The cladding must be made in such a
way that the user cannot gain access to
hazardous parts.
The installation and maintenance of the
product must be carried out exclusively
by qualified personnel with suitable
knowledge of the product itself. Use
only original spare parts recommend-
ed by the manufacturer.
Responsibility for the works carried out
in the location of the appliance is, and
remains, with the user; the latter is also
responsible for carrying out the checks
relating to the proposed installation
solutions.
The installer must comply with all
local, national and European safety
regulations.
The appliance must be installed on
floors with adequate load bearing
capacity.
004779040 - 21/03/2022
ITALIANO ENGLISH DEUTSCH
Check that the chimney flue
and air inlet set-ups conform to
the type of installation.
Before starting the assembly or dis-
assembly phases of the appliance,
the installer must observe the safety
precautions required by law and the
following instructions in particular:
• do not operate in adverse conditions;
• they must operate in perfect psy-
chophysical conditions and must
check that the personal protective
equipment is intact and functioning
perfectly;
• they must wear gloves and safety
shoes;
• they must use tools with electrical
insulation;
• they must make sure that the area
used during assembly/dismantling is
free from obstacles.
The product must only be installed
in rooms that are not subject to fire
hazards and must be equipped with
all the necessary facilities including air
supplies and flue gas exhausts.
Evaluate the static conditions of the
surface bearing the weight of the prod-
uct and provide suitable insulation if it
is composed of flammable materials
(e.g. wood, carpet, plastic).
FRANÇAIS ESPAÑOL
33