Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GE 150.1:
Weight
26 kg
27 kg (GB)
L/W/H
95/48/114 cm
GE 250.1/GE 250.1 S:
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L
103/100 dB(A)
WAd
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L
92/90 dB(A)
pA
Uncertainty K
3 dB(A)
pA
Bolt tightening torques:
Blade disc
50 Nm
Reversible blade
10 Nm
2
Shredding blades
10 Nm
Weight
28/27 kg
29/28 kg (GB)
27 kg (CH)
L/W/H
107/48/143 cm
GE 260.1/GE 260.1 S:
Motor, type
BSRF 0.75/2-C
Power
2900 W
Amperage rating
4.8 A
Rated voltage
400 (3~) V~
Speed
2780 rpm
Fuses
10 A
Frequency
50 Hz
Protection class
I
Type of protection
Splash proof
(IP X4)
52
All manuals and user guides at all-guides.com
GE 260.1/GE 260.1 S:
Operating conditions
In accordance with
Directive
2000/14/EC:
Guaranteed sound
power level L
WAd
In accordance with
Directive
2006/42/EC:
Sound pressure level
at workplace L
pA
Uncertainty K
pA
Bolt tightening torques:
Blade disc
Reversible blade
2
Shredding blades
Weight
L/W/H
Caution:
1)
In the case of mains fuses of less
than 16 A, these may be tripped dur-
ing start-up or in the case of high
load operation of the machine.
2)
for models GE 250.1 and GE 260.1
S6/40%
19. Troubleshooting
4 min
Load time 6 min
If necessary, contact a specialist
Idle time
dealer; VIKING recommends VIKING
specialist dealers.
Fault:
102/101 dB(A)
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
89/91 dB(A)
switch defective
3 dB(A)
– Feed chute not properly closed - safety
cut-off switch actuated (motorstop)
– Blade disc blocked
50 Nm
– Locking device is not reset
10 Nm
Remedy:
10 Nm
– Allow machine to cool down (
28/27 kg
– Check power cable and fuse
107/48/143 cm
– Check cable, plug, connector and
switch and replace if necessary (by
electrician)
– Close feed chute properly and tighten
screws (
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
(
– Reset locking device (
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades
(
10.1)
(
10.1)
11.2)
11.3)
11.4)
(
11.7)
0478 201 9906 C - EN
8.6)
Werbung
Inhaltsverzeichnis
